Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Kitchen Remodeling: The Irvine Owner’s Guide
Schluter kitchen remodeling in Irvine typically runs $14,000 to $45,000 installed, depending on tile scope, square footage, and whether the project includes a full tear-out or a refresh over sound substrate. Small kitchen projects fall between $9,000 and $20,000. We install Schluter-compatible systems in Irvine kitchens and can usually get a crew out the same week you call. Groundwork Construction Co. of Irvine is an independent installer, not affiliated with Schluter.
Owners usually find a problem the same way: a hairline crack spreading across three or four grout lines, a hollow thud when they tap a tile near the sink, or a faint mildew smell coming from under the kitchen peninsula after a dishwasher leak. The tile itself is almost never the failure. It’s the system underneath it – the uncoupling membrane, the waterproofing layer, or the bonding flange at a shower or sink penetration – and that’s where the real diagnosis starts.
Which Schluter Models This Applies To
Schluter isn’t one part. It’s a family of tile installation systems, and knowing which one is under your kitchen floor changes how the repair gets scoped. The most common in Irvine kitchens are DITRA uncoupling membrane (the most common under floor tile), DITRA-HEAT for heated kitchen floors, KERDI waterproofing membrane (used behind backsplash and any wet penetration), KERDI-BOARD foam backer panels, and SCHIENE or JOLLY profile strips at exposed tile edges.
To identify what you have, pull a floor register or the vent by the toe kick and look at the edge of the tile assembly. DITRA reads as an orange plastic mesh mat roughly 1/8-inch thick with square dimples. KERDI is a flat orange fleece-backed sheet. DITRA-HEAT has the same orange dimples plus a visible matte-black heating cable woven through it. If you can’t see a cross-section, a small test cut under a cabinet toe kick usually tells you in five minutes.
On the OEM-versus-aftermarket question: for Schluter specifically, there is no true aftermarket equivalent for DITRA and KERDI that carries the same certification. Generic uncoupling membranes exist at half the price, but they don’t carry the same ANSI A118.10 waterproofing or A118.12 crack-isolation ratings, and using them can void a tile manufacturer’s warranty. The membrane itself is a small fraction of the total labor line, so the savings rarely justify the risk.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Kitchen Remodeling Is Failing
- Hollow-sounding tile underfoot. Tapping a few tiles near the sink or dishwasher with a coin should sound solid. A dull “thunk” means the membrane has debonded from the substrate or the thinset under it has lost grip – often from migrational moisture pushing up through a concrete slab in Irvine’s older ranch homes.
- Grout cracks in straight, repeating lines. Cracks that follow a consistent direction across three or more tiles usually mean deflection in the subfloor, not just a failed grout joint. DITRA is designed to absorb deflection up to a point – past that point, the membrane separates.
- Mildew smell near the base of cabinets or the peninsula. That’s trapped moisture under a KERDI or DITRA layer that wasn’t properly sealed at a penetration. In Irvine’s dry climate, smells coming through a kitchen floor are almost always supply-line or dishwasher leaks, not humidity.
- Loose tile at the base of a Schluter profile edge. SCHIENE and JOLLY profiles need full thinset coverage behind the anchoring leg. A tile that rocks or lifts along a counter edge or threshold usually points to a profile that was set with too little mortar.
- A heating mat that trips a GFCI. DITRA-HEAT cable faults are usually caused by a nick during tile setting, not a cable defect. Tripping GFCIs should stop all use of the mat until it’s diagnosed.
Replacement Cost & What’s Included
Full kitchen remodel with a Schluter tile system in Irvine runs $14,000 to $45,000. A small kitchen refresh falls in the $9,000 to $20,000 band. Those numbers are installed, not just materials. For context on line items:
- Backsplash installation: $800 to $2,500
- Countertop installation: $2,000 to $6,500
- Cabinet installation: $4,000 to $13,000
- Kitchen island installation: $3,000 to $10,000
The range is driven by square footage of tile, whether the substrate is a slab or raised wood subfloor, whether old tile has to be demoed and hauled, and whether DITRA-HEAT is being installed as new construction. What’s included at our price: Schluter materials sourced at job-spec quantity, proper substrate prep, and every project covered by our 730-Day Done Right Promise – if the installation fails, we make it right, in writing. Our technicians have up to 12 years of experience.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some of this you can safely check yourself. Lift a floor register to confirm what membrane is installed. Tap a few square feet of tile with a coin. Look under the sink and dishwasher for signs of an active leak. Feel the floor near the perimeter of the room for soft or spongy spots.
Where DIY goes wrong: replacing a Schluter membrane is not a patching job. It requires demoing down to substrate, re-leveling, resetting thinset to Schluter’s specified coverage, and re-waterproofing any wet-area penetration. A patched membrane over a wet substrate will fail again – usually within a year – and DIY patching also voids whatever warranty the original install carried. If you don’t know whether you have DITRA or DITRA-HEAT, don’t pull up a tile to find out. Call our team at (888) 578-4462 and we’ll walk you through identification and give you a free estimate.
FAQs
Properly installed DITRA and KERDI under kitchen tile typically last 25 to 40 years. The realistic failure mode is never the membrane itself – it’s the thinset coverage beneath it, a missed seam, or a penetration that wasn’t sealed. In Irvine’s seismic zone, deflection in raised wood subfloors is the most common cause of early failure. If the system was installed correctly, you shouldn’t need to touch it for decades. Call (888) 578-4462 for a free inspection if you’re not sure what’s under your tile.
Sometimes. A localized membrane failure under three or four tiles can often be cut out and rebuilt – demo the affected tile, patch the uncoupling layer, re-waterproof any penetration, and re-set new tile. A field-wide failure (cracks spanning ten or more tiles, hollow sound through half the room) usually means the whole floor assembly comes out. The scope is decided by how much of the membrane has lost bond, not how bad the visible crack looks. Call (888) 578-4462 and we’ll tell you which side of that line your kitchen is on.
A localized patch is usually a single full day: demo, substrate prep, membrane reset, tile set, and grout the following day. A full kitchen tile system replacement moves to three to five working days, and if cabinets or counters are involved the schedule extends toward the upper end of the remodel range. We give you a written schedule before we start – not a window we hope to hit.
We source Schluter materials from authorized distributors at exact job-spec quantity, ordered per project – we don’t keep parts on a truck or claim a warehouse stock. That means your membrane arrives factory-sealed with the batch documentation matching what Schluter specifies for your install, and there’s no risk of a dusty roll that’s sat in a garage for two summers. For finished surfaces we work in KraftMaid cabinetry, Cambria and Silestone countertops, and Schluter-listed installation systems – all coordinated under one schedule and one warranty.
Get a Free Estimate in Irvine
Whether you’re facing a single cracked tile or a full kitchen rebuild, the diagnosis has to come first. Groundwork Construction Co. of Irvine answers every call with a live person, 24/7, and every estimate is free with upfront pricing – the number you see is the number you pay. We’re running $1,000 off projects over $10,000 and 0% financing for 18 months on approved projects, and every kitchen we build is covered by our 730-Day Done Right Promise. Call (888) 578-4462 today to schedule your free estimate and get a straight answer on what’s under your tile.
Written by the team at Groundwork Construction Co. of Irvine, serving Irvine and nearby areas.