Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Santa Ana, CA
Concrete driveways and concrete work in Santa Ana run $4,500 to $12,000 for a full driveway installation, and most residential pours here are finished in three to five working days once we start. That covers demolition of the old slab, grading, formwork, a base of compacted class II aggregate, rebar or mesh set on chairs, and a pour finished with your choice of surface. Steps, aprons, walkway sections, and small utility pads sit lower, often $800 to $3,000 depending on square footage and access. Call (888) 578-4462 to schedule a free on-site estimate, and we’ll measure the actual driveway footprint and give you the number in writing.
How a concrete job moves from demolition to a driveable slab
The sequence matters more than anything else on a concrete pour, because every later stage depends on the one before it. Here’s what actually happens across those three to five days.
Day 1 – Demolition and site prep. We break out and haul off the existing slab or cut away soil and vegetation for a new one. We mark utility locates before anything is cut; this is non-negotiable. You’ll confirm the driveway boundaries and where the apron meets the street.
Day 2 – Grading and base. We grade to positive fall away from the garage so water doesn’t pool at the door, then lay compacted aggregate base to the correct depth. On sloped sites, grading is where most of the labor goes. This is when you decide whether to widen the driveway or add a walkway section.
Day 2-3 – Formwork and reinforcement. Wood or steel forms set the edges and the control-joint layout. We set rebar or wire mesh on chairs so it stays in the middle of the slab rather than sinking. This is the step you’ll want to look over with us; it defines the final grade and joint lines.
Day 3-4 – The pour. Ready-mix arrives, gets placed, screeded, and floated. We add control joints on a grid to direct cracking. If you chose a broom finish, a stamped pattern, or an exposed aggregate look, this is the window for it. Everyone stays off the slab from here.
Day 4-5+ – Cure and cleanup. Concrete cures over days-to-weeks; we cover or cure-seal per the schedule and keep traffic off it for at least 7 days, with vehicles off for 28. We pull forms, clean up, and walk the finished job with you.
Homeowners often pair a new concrete apron with a Garage Conversion ADU in Santa Ana, since that project changes the driveway access and tie-in at the garage door anyway.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The concrete choices you’ll actually make
Concrete isn’t one product. What you pick sets the cost, the look, and how long the slab lasts. Here are the decisions in front of you:
- Finish – broom, stamped, or exposed aggregate. Broom-finish standard concrete is the most affordable and the most slip-resistant, ideal for a working driveway. Stamped patterns give you a paver look at a lower price than real pavers but can be slicker when wet and wear unevenly on a driven surface. Exposed aggregate hides tire marks and lasts well but is rougher underfoot and harder to patch later.
- Thickness. 4-inch slabs are standard for light residential driveways. 5 to 6 inches with heavier reinforcement is worth it where a truck or heavy trailer parks. It adds material cost but cuts the risk of cracking under load.
- Reinforcement. Wire mesh is the basic option; rebar set on chairs holds up better on clay-heavy soils and longer spans. For anything wider than a standard driveway, we lean toward rebar.
- Color and sealant. Integral color or a colored hardener changes the look at a modest cost. A cure-and-seal coat protects the surface and slows moisture intrusion; resurfacing and resealing later fall under Driveway & Pavers maintenance work we can quote.
- Joints and layout. Control-joint spacing, driveway width, and expansion-joint placement where the slab meets the garage or street. This is where a driveway is designed, not just poured.
Choose the finish and layout based on how the driveway gets used, not just how it photographs. A stamped driveway looks great on day one and needs more care a few years in.
What Concrete Driveways & Concrete Work costs in Santa Ana, CA
Across Santa Ana, concrete driveway installation runs $4,500 to $12,000 and full replacement (demo plus new pour) runs $5,000 to $14,000. Here’s what moves a job to the low or high end of that range:
- Square footage. A short single-car apron sits near the bottom; a long double-wide driveway with a turnaround pushes toward the top.
- Existing slab condition. Thick old concrete with rebar is more demolition and haul-off than a thin cracked slab, and that’s labor you can’t shortcut.
- Site access and grading. Tight alley access, slopes that need retaining, or a lot that needs extra base all add cost.
- Finish and reinforcement. Broom-finish standard concrete is the baseline; stamped, colored, or exposed aggregate and heavier rebar add to the number.
- Related concrete. Walkway sections, steps, aprons, or a patio poured in the same visit can save on mobilization versus a separate job.
A written line-item estimate includes the demo, haul-off, base material, reinforcement, forms, the pour, finishing, curing, and cleanup, plus the permit fee if one is required. It usually does not include utility relocation or structural repairs discovered under the slab, root removal, or planting and landscaping afterward. If the driveway is part of a wider project, that work falls under Driveway & Pavers in Santa Ana.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Ana homes specifically do to this job
Santa Ana’s housing stock changes how a concrete job goes. Much of the city’s housing dates from the 1920s through the 1960s, and the wood-frame bungalows and Spanish Colonial Revival homes in neighborhoods like Wilshire Square and French Park often have buried galvanized plumbing and wiring running where a new driveway base needs to go. Before we cut, we locate and confirm; this is the step that keeps a driveway pour from turning into a plumbing repair. And because the stock is older, it’s common to find a garage that was converted or added without permits; that can affect how the driveway ties in at the garage door and may require code work before a larger project is permitted. Santa Ana’s semi-arid climate helps here: hot, dry summers mean less rain delay than the coastal cities, so we can schedule pours tighter, but a concrete slab sitting on clay-heavy soil needs correct base and joint spacing to keep from cracking. Our team also handles New Detached ADU in Santa Ana projects where a new driveway apron and access are part of the plan.
Serving Santa Ana, CA – Our Local Coverage Area
We serve Santa Ana and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Concrete Driveways & Concrete Work in Santa Ana
Most concrete driveways in Santa Ana take three to five working days from demolition to cleanup, plus a cure period before you can park on them. The pour itself is usually one day; the rest is demo, base, forms, reinforcement, and finishing. Plan on keeping vehicles off the new slab for about a week and heavy vehicles off for roughly a month. Call (888) 578-4462 for a timeline on your actual lot.
A permit requirement in Santa Ana depends on scope: a like-for-like replacement on private property often doesn’t need one, while a new driveway approach that ties into the city right-of-way usually does. We confirm the requirement during the estimate and handle the paperwork and inspection if it applies. Don’t guess on this one; a denied tie-in can delay the whole job. Call (888) 578-4462 to check your address.
In most cases, yes. A standard driveway pour doesn’t disturb plumbing or framing so long as the subgrade is sound and utilities are located and clear of the new base. Where old galvanized lines run under the slab, we locate them first and route around or protect them. If something is in the way, we tell you before we cut rather than after. Call (888) 578-4462 for an on-site look.
Concrete driveway installation in Santa Ana runs $4,500 to $12,000, and full replacement runs $5,000 to $14,000. The finish, thickness, reinforcement, square footage, and existing slab condition drive where you land in that range. Walkway sections and small pads are quoted separately and often cost less when poured with the driveway. Call (888) 578-4462 for an exact quote; estimates are free.
Our concrete driveways are covered by the 730-Day Done Right Promise: if the work isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it applies to this job the same as every other. Ask us to put the coverage in writing on your estimate so there’s no fine print. Call (888) 578-4462 to schedule.
Get a free on-site estimate for your Santa Ana driveway
We’ll walk the driveway footprint with you, check the existing slab, discuss finish and layout, and leave you with a written line-item quote and the 730-Day Done Right Promise behind it. We cover Santa Ana and the surrounding neighborhoods. When you call (888) 578-4462, a live person answers around the clock, and we’ll set up a time that works for you. Our technicians have up to 12 years of experience on concrete.
Written by the team at Groundwork Construction Co.