Roofing
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Metal Roofing in Costa Mesa, CA: What the Job Actually Involves
Metal roofing in Costa Mesa runs $15,000 – $40,000 for a typical west-side or South Coast Metro home, and most installs take 3 – 7 working days once materials land on site. The job means tearing off the old roof, replacing or sistering damaged sheathing, fitting underlayment and new flashing at every penetration, then setting standing-seam or stone-coated steel panels and passing city inspection. Call (888) 578-4462 and we’ll walk you through what your particular roof is going to need before anyone touches a panel.
How We Install a Metal Roof, Stage by Stage
Metal roofing isn’t a one-day swap, and anyone telling you otherwise is skipping steps. Here’s the actual sequence we run, with realistic durations and the decisions that land on you at each point.
Stage 1: Tear-off and deck inspection (1 – 2 days)
We strip the old roofing down to the sheathing so we can see what’s really there. On the 1950s and ’60s homes common in Costa Mesa, that’s often the moment we find dry-rotted fascia or a few soft spots in the deck. You decide whether we replace spot sheathing or over-frame with a new layer, and we quote the difference in writing before proceeding.
Stage 2: Structural and flashing prep (1 day)
Metal is lighter than tile but demands clean, flat planes and correct attachment. We fasten new underlayment, set ice-and-water membrane in the valleys, and rebuild the flashing at chimneys, skylights, and wall intersections. You confirm where vents and any roof-mounted equipment will land before we cut.
Stage 3: Panel set and fastening (2 – 3 days)
Panels go up in measured runs, screwed and lapped to the manufacturer’s spec so the wind warranty holds. This is where crew count and roof pitch drive the calendar. On a steep 1950s hip roof, expect the longer end.
Stage 4: Trim, ridge, and penetrations (1 day)
Ridge caps, gable trim, and pipe boots close the roof out. You choose trim color here; it’s the one cosmetic decision that isn’t already locked by the panel selection.
Stage 5: Inspection and walkthrough (same week)
We schedule the city inspection and walk the finished roof with you, showing you the attachment pattern and handing over the manufacturer’s warranty paperwork. Nothing is marked complete until you’ve seen it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Metal Roofing Options You’ll Choose Between
Most Costa Mesa homeowners land on one of a handful of real choices. Here’s what each one actually means for your roof and your budget.
- Standing-seam steel: the premium call. Concealed fasteners, 40-plus years of life, clean lines. Higher material cost and requires an experienced installer because the seams are formed on site.
- Stone-coated steel: a steel panel with a granular coating that mimics tile. Popular on west-side homes where the neighbors’ rooflines are tile and you still want a metal system.
- Exposed-fastener panels: the budget option. Cheaper and faster to install, but the screws are your long-term maintenance point, especially near the coast where salt air works on them.
- Panel gauge and finish: heavier gauge lasts longer but costs more; a quality factory finish with a Kynar or similar coating holds color far better than a basic paint in marine air.
- Underlayment: a synthetic high-temp membrane beats standard felt under metal; it’s a small line item that buys years of protection.
We source panels from manufacturers like CertainTeed and Owens Corning where their metal lines fit the job, and we’ll show you the spec sheets side by side so the choice is yours, not ours.
What Metal Roofing Costs in Costa Mesa, CA
Plan on $15,000 – $40,000 for a full metal roof installation in Costa Mesa. The number moves on five things: roof size and complexity, existing deck condition, panel type and gauge, the amount of flashing and penetration work, and permit scope. A simple gable on a 1,200-square-foot home sits near the bottom; a cut-up hip roof with multiple valleys and a chimney pushes toward the top.
Your written estimate should itemize tear-off, sheathing repair allowance, underlayment, panels, trim, flashing, labor, disposal, and permits. What it usually won’t include until we’re on the roof: hidden rot or structural repair, which we quote separately before doing the work. Upfront pricing, no surprises – the number you see is the number you pay, and every project carries our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Costa Mesa Homes Do to a Metal Roofing Job
Costa Mesa splits into two very different roofing realities. West of the 55, the 92627 neighborhoods near the beach are packed with 1950s and ’60s single-story stucco tracts on small lots, and that marine layer and salt air eat exterior wood and fasteners faster than anything inland. On the east side around 92626 and South Coast Metro, you get larger lots, some two-story additions, and more commercial-adjacent buildings where the roof spans are bigger and the flashing details multiply. Permitting here gets real attention to setbacks and lot coverage, and second-story or rebuild projects often need the boundary verified before we start – which is routine on the west side, where 60-year-old fences sit right on the property line and material deliveries sometimes can’t reach the rear of the lot at all.
Metal handles the coastal salt air better than most roofing materials, but the fasteners and flashing still have to be spec’d for it. That’s the detail that separates a metal roof that lasts from one that rusts at the penetrations in a decade.
Serving Costa Mesa, CA – Our Local Coverage Area
We serve Costa Mesa and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions About Metal Roofing in Costa Mesa
Most metal roofing jobs here run 3 – 7 working days from tear-off to final inspection, weather permitting. Larger or steeper roofs land at the top of that range. Call (888) 578-4462 for a schedule estimate on your specific home.
Yes, a full roof replacement or re-roof requires a permit and inspection in Costa Mesa. We pull the permit and manage the inspection as part of the job, so you’re not chasing the city yourself. Have a question on scope? Call us and we’ll explain.
Usually yes, since metal is lighter than tile, but the deck has to be sound and the attachment correct. On older west-side homes we inspect the sheathing first and quote any repair separately. Call (888) 578-4462 for a free on-site look.
Metal runs $15,000 – $40,000 here, generally more than shingle and comparable to premium tile on a like-for-like roof. If you’re weighing it against a full roof replacement, our Roofing in Costa Mesa page breaks down the comparison. Estimates are free.
You get the manufacturer’s warranty on the panels and our 730-Day Done Right Promise on the workmanship. Every job is backed in writing. Call (888) 578-4462 to talk through coverage.
Get a Free Metal Roofing Estimate in Costa Mesa
If you’re weighing metal roofing for a home in Costa Mesa, start with a free on-site estimate. Call (888) 578-4462 and a live person answers – day or night. We’ll measure the roof, check the deck, talk through panel options, and hand you an itemized written quote with financing available at 0% for 18 months. It’s the same crew standard we bring to every job, and it’s part of a full scope that can include roofing and Impact Windows & Doors in Costa Mesa if you’re upgrading the whole envelope, or Window Replacement in Costa Mesa down the line.
Written by the team at Groundwork Construction Co.