Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Fountain Valley, CA
Concrete Driveways & Concrete Work in Fountain Valley usually means replacing a cracked, settled slab on a 1960s – 70s tract lot rather than pouring fresh on open ground. A standard two-car driveway runs $4,500 – $12,000, with most Fountain Valley jobs landing near $7,000 – $9,000 once demolition, haul-off, base prep, rebar and a broom finish are included. Plan on two to four working days from tear-out to the first drive. Call (888) 578-4462 for a free on-site estimate with a written, line-item number before anyone lifts a pickaxe.
Concrete Driveways & Concrete Work in Fountain Valley means replacing or repairing a slab on a lot that was graded and poured decades ago. Most of our work here is full tear-out and repour: $4,500 – $12,000 depending on square footage, thickness, base depth and access. Plan on 2 – 4 working days of actual concrete work plus permit time with the city. Call (888) 578-4462 to schedule a free on-site estimate with a written line-item quote.
What does the work actually involve, from tear-out to cure?
Concrete looks simple until you watch a slab fail in three years because somebody skipped base compaction. Here’s the sequence we run, and where you make decisions.
Stage 1: Estimate and layout (day of the estimate)
We measure the existing slab, check the subgrade, note the slope toward the street and look at what abuts the pour: garage stem wall, sidewalk, planters, gas meter, downspouts. You decide the width you want (a standard double at 18 – 20 feet, or a wider one if you park a truck and a second car) and where the expansion joints land. That afternoon you get a written scope.
Stage 2: Permits and HOA (usually 1 – 3 weeks in Fountain Valley)
Most driveway replacements need a city permit because the apron meets the public right-of-way, and some HOA rules in the tract neighborhoods dictate finish color or width. We pull the permit and put the haul-away and inspection dates on paper. You sign once. The lead time here is the city and HOA, not the crew.
Stage 3: Demolition and haul-off (day 1)
A 400-square-foot slab is roughly 5 cubic yards of broken concrete, and it leaves in a dump truck the same day. We saw-cut clean edges at the garage and sidewalk so the new pour ties in, then break and remove. If a root from a parkway tree runs under the slab, this is when it shows up.
Stage 4: Base, rebar and forms (day 2)
We excavate to the depth the slab needs, compact the base in lifts, set rebar on chairs and build forms to the correct slope. You or the inspector look at it before the pour. This is the stage that separates a driveway that lasts decades from one that cracks at the first Santa Ana heat wave.
Stage 5: Pour, finish, cure (days 3 – 4, then 7 days of care)
We pour, screed, float and finish to the pattern you picked, cut control joints, and then the slab cures. Keep cars off it for about 7 days and heavy loads off for 28. That’s the whole job, and it’s also the whole cost.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
For this job the choices are thickness, reinforcement, finish and joints. Each one moves the number.
- 4-inch standard vs 5 – 6-inch heavy-duty: A 4-inch slab handles a sedan fine. If you park a truck, an RV or anything heavy, pay for 5 – 6 inches. The extra concrete runs a few hundred dollars and prevents the spider-cracking you see on thin tract driveways.
- Rebar vs mesh: Rebar on chairs costs more but holds the slab together when the ground shifts. Mesh is cheaper and fine on a small flat pour. We’ll tell you which your soil wants.
- Broom finish vs exposed aggregate vs stamped: Broom is the default, most slip-resistant option and the cheapest. Exposed aggregate runs higher and hides tire marks well. Stamped finishes run highest and look striking, but they’re surface-textured and can chip at the edges – best for a front walk or an accent band, not a whole driveway.
- Control joints and expansion joints: We cut joints on a grid so cracks land where you can’t see them. Ask where they’ll go before the pour, not after.
- Drainage and slope: The slab has to shed water toward the street or a drain, not into the garage. On a tight Fountain Valley lot with no side-yard room, this is usually the biggest design decision.
What Concrete Driveways & Concrete Work costs in Fountain Valley, CA
A full driveway replacement here runs $5,000 – $14,000; a straight install on a good existing base runs $4,500 – $12,000. Small repairs, slab lifts or joint sealing land lower, usually $250 – $700. Here’s what’s included in our written estimates and what typically isn’t.
- Square footage: The driver. A single-car apron is a fraction of a full double driveway.
- Existing condition: A slab that’s cracked and settled needs more excavation and base work than one that’s just ugly.
- Access and side-yard width: If a concrete truck can’t reach the pour, we pump or wheelbarrow it, and that adds labor.
- Reinforcement and thickness: Rebar and 6-inch slabs cost more than mesh and 4-inch.
- Permit and inspection scope: City permits, right-of-way work and any sidewalk repair add to the total.
Included: demolition, haul-off, base prep, rebar, forms, pour, finish, joints, cleanup and the city inspection. Not included unless we write it in: landscape repair, moving irrigation, or widening the apron. That’s upfront pricing, no surprises, and it’s why the quote is line-itemed.
See the difference
Before
After
Before
After
Before
AfterWhat Fountain Valley homes specifically do to this job
Fountain Valley was built out almost entirely as a master-planned bedroom suburb in the 1960s and 70s, so almost every driveway we touch is a rebuild on a fixed tract footprint, not a pour on fresh ground. That changes the job in three ways. First, the original slabs are often 50-plus years old and have done their time; the base under them is settled and sometimes undercut by tree roots. Second, lots are tight, so side-yard access to the back of the property is limited and a truck may not reach, which is why we plan pours around access. Third, because the city is built out with little vacant land, new work means working within setback and lot-coverage limits, not greenfield grading. The coastal-adjacent climate helps: mild, dry summers mean year-round pours with few weather delays, though Santa Ana winds bring hot, dry, dusty conditions that can flash-cure a slab if the timing is wrong. We see the same failure modes repeatedly: hairline cracks from skipped control joints, spalling at the apron where winter rain pooled, and settled sections in front of the garage. If you’re also reworking the front of the house, homeowners often pair this with Driveway & Pavers in Fountain Valley scope that ties the driveway to a new walkway or patio, and some pair it with a Garage Conversion ADU in Fountain Valley or a New Detached ADU in Fountain Valley that changes the driveway approach and drainage plan.
Serving Fountain Valley, CA – Our Local Coverage Area
We serve Fountain Valley and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Concrete Driveways & Concrete Work in Fountain Valley
Plan on 2 – 4 working days of construction, plus 1 – 3 weeks of permit and HOA wait before that. The pour itself is one day; curing is the rest. Call (888) 578-4462 for a schedule based on your lot.
Usually yes, because the apron meets the public right-of-way, and many HOA-governed tracts also require approval for finish and width. We pull the permit and arrange the inspection as part of the job. Call (888) 578-4462 for a read on your specific address.
Sometimes. If the existing slab is sound, level and correctly sloped, an overlay can work and saves money. If it’s cracked or settled, an overlay just fails faster. We’ll tell you honestly. Call (888) 578-4462 for an on-site assessment.
A full replacement runs $5,000 – $14,000 and a straightforward install runs $4,500 – $12,000, with small repairs and sealing at $250 – $700. Size, thickness, access and existing condition move the number. Call (888) 578-4462 for an exact quote – estimates are free.
Not on our jobs. We quote line-item and hold the number unless you change the scope. If something surprises us under the slab, we stop and talk to you before spending a dollar. The 730-Day Done Right Promise covers the workmanship either way. Call (888) 578-4462 to get started.
Get a free estimate for your Fountain Valley driveway
Call (888) 578-4462 for a free on-site estimate on Concrete Driveways & Concrete Work in Fountain Valley. We’ll measure the slab, check the base and access, and hand you a written line-item quote with permits and cleanup included. A live person answers 24 hours a day, and our technicians arrive background-checked and in uniform.
Written by the team at Groundwork Construction Co.