Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Midway City, CA: What to Expect
Paver driveways in Midway City, CA typically cost $7,000 – $18,000 installed, and a standard 20-foot-wide drive on a 5,000 – 6,000 sq ft lot takes about 3 – 5 working days once materials are on site. You’re buying base work, drainage, and compacted subgrade as much as you’re buying pavers, and on Midway City’s tight post-war lots the prep is where the money goes. Call (888) 578-4462 for a free on-site estimate.
How We Build a Paver Driveway, Stage by Stage
A paver driveway is only as good as what’s under it. On Midway City’s older lots we spend real time on the base because the base is what stops settling, rutting, and pavers that shift after the first Santa Ana wind season. Here’s the actual sequence.
Stage 1: Site check and layout (half a day)
We measure the drive, note the slope away from the garage slab, and confirm where water currently goes. Because most Midway City lots have no alley access and run about 50 feet wide, we plan how trucks stage and where equipment sits without blocking neighbors. You decide the paver pattern and border color at this point.
Stage 2: Demo and excavation (1 – 2 days)
Existing concrete, old asphalt, or dirt gets removed and hauled off. We excavate to depth for your chosen base: usually 6 – 8 inches of compacted aggregate for a car drive, deeper if a heavy truck or RV parks on it. On Midway City properties we check for old sprinkler lines, cleanouts, and the original 1950s garage apron before digging further.
Stage 3: Base, grading, and compaction (1 day)
Aggregate goes down in lifts and gets plate-compacted in layers, not all at once. We set fall so water runs to the street or a drainage point instead of pooling against the garage. This is the stage a homeowner can’t see later but will feel for the next 15 years.
Stage 4: Edge restraint and bedding course (half a day)
We set a concrete or poly edge restraint so the pavers can’t spread, then screed a bedding layer to final grade. You confirm the border and any accent band before the field goes in.
Stage 5: Paver installation, cuts, and joint sand (1 – 2 days)
Field pavers go down, edges get cut, and the surface is compacted again before polymeric joint sand is swept in and activated. We leave the drive clean and walkable same day, with a short cure window before you park a heavy vehicle on it. Any drainage or garage-grade issue gets flagged before we close out, and if you’re considering converting that garage later, homeowners often pair this with Garage Conversion ADU in Midway City planning so the apron and slab heights line up.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Paver Options You’ll Actually Choose Between
Most of the decision comes down to paver type, thickness, and pattern. Here’s the honest trade-off on each.
- Concrete pavers, 60mm: The workhorse for driveways. $7,000 – $13,000 on a typical Midway City drive. Holds up to vehicle load, easy to lift and replace a single damaged unit, and comes in a wide color range. The default for good reason.
- Concrete pavers, 80mm: Thicker and heavier-rated for driveways that take trucks, trailers, or regular heavy loads. Pushes toward the top of the range, but worth it if you actually park something heavy on it.
- Clay brick pavers: Warmer color that deepens with age and a classic look on older ranch homes. Higher cost and a bit more care, since a frost-tender clay can chip where concrete doesn’t.
- Permeable pavers: Open-joint or pervious units that let water through. Useful where runoff is a problem, though the base build is different and the price sits higher.
- Pattern and border: Running bond is the budget-standard; herringbone and basketweave cost more in labor and cuts but read as a premium finish. A contrasting border adds visual structure for a modest upcharge.
On materials, we work with a curated set of brand partners. Belgard is the most common choice for a driveway like this because their color and shape range fits both the ranch style and the tighter footprints common here. We source what actually suits your lot and budget rather than steering you to whatever’s on hand.
What Paver Driveways Cost in Midway City, CA
Paver driveway installation in Midway City runs $7,000 – $18,000 for a standard residential drive. Here’s what moves a job toward the low or high end:
- Square footage: The single biggest factor. A short 20-foot drive lands near the low end; a long run to a detached rear garage on an acreage-style lot climbs toward the top.
- Existing condition: Removing and hauling old concrete adds cost over a dirt or gravel drive you’re paving fresh.
- Base depth: Heavy-duty base for trucks and oversized doors pushes the number up, and it’s the part you don’t want to skimp on.
- Paver grade and pattern: 60mm running bond is the baseline; 80mm, clay brick, herringbone, and borders add labor and material.
- Drainage and grading: If water needs to be redirected or a drain installed, that’s real scope.
A written estimate from us is line-itemed and fixed: the number you see is the number you pay, with no change orders for the scope we quoted. What’s included is demo, haul-off, base, compaction, edge restraint, pavers, cuts, and joint sand. What’s typically not included is anything outside the driveway footprint, like a walkway or patio, which falls under our broader Driveway & Pavers work. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Midway City Homes Specifically Do to This Job
Midway City is a small, landlocked unincorporated Orange County community in ZIP 92655, and that shapes the work here. Because there’s almost no vacant land, this is a tear-down, addition, and rebuild market on tightly packed 1950s-era ranch lots, not new subdivision builds. Permits go through the County of Orange rather than a city building department, which changes plan-check timelines and inspection scheduling, so we build that into the calendar instead of promising dates we can’t hold.
The physical layout matters just as much. With no alley access and many lots only about 50 feet wide, staging a demo trailer or a material delivery means planning ahead, sometimes staging on Bolsa Avenue or Hazard Avenue during off-peak hours. Neighbors’ fences and mature trees sit right on the property line, so we confirm boundaries before we touch the ground, a common source of pre-construction disputes on these lots. The coastal-adjacent basin means no freeze days to work around, but dry Santa Ana conditions kick up dust and demand careful curing and dust control during exterior work. And because the housing stock is original stucco and older garage slabs, we check the existing apron and drainage before we build over it. Our technicians have up to 12 years of experience, and every job is covered by our 730-Day Done Right Promise, so if something settles or shifts, we make it right.
Serving Midway City, CA – Our Local Coverage Area
We serve Midway City and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Paver Driveways in Midway City
A standard paver driveway in Midway City takes about 3 – 5 working days from demo to joint sand, weather and material lead times permitting. Larger drives with heavy-duty base or drainage work can push toward a week. Call (888) 578-4462 to get a timeline for your specific lot.
Paver driveway resurfacing on an existing footprint often doesn’t require a permit, but work that changes grade, drainage, or the driveway’s footprint can, and here it goes through the County of Orange. We confirm what your job needs before work starts and pull what’s required.
Yes. A paver driveway replaces the surface and base, so in most cases it doesn’t touch plumbing or structure. If you’re also planning a home addition, that scope is handled separately through ADU Design & Permitting in Midway City. Call for a free estimate on the driveway itself.
Paver driveway installation in Midway City typically costs $7,000 – $18,000, driven by size, base depth, paver grade, pattern, and existing demo. Call (888) 578-4462 for an exact line-itemed quote, free on site.
Our paver driveways are backed by the 730-Day Done Right Promise: if it’s not done right, we make it right. That covers workmanship on the install, with manufacturer coverage on the pavers themselves. Call for the full written terms.
Get a Free Paver Driveway Estimate in Midway City
We’ll come out, measure the drive, look at the existing base and drainage, and hand you a line-itemed written estimate at no cost. You’ll know the price before you commit, and it won’t move once work starts. Call (888) 578-4462 to schedule yours. If the wider project scope is part of the plan, start with Driveway & Pavers in Midway City to see everything that fits together, and see where else we work on our Midway City service-area page.
Written by the team at Groundwork Construction Co.