Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Westminster, CA: What the Job Actually Involves
Choosing vanities, tile and fixtures in Westminster, CA usually runs $9,000 – $28,000 when you’re pairing a new vanity and sink with floor tile, a tub or shower surround, and fresh fixtures – and most jobs land in the $9,000 – $16,000 range once plumbing stays put. Schedule a free on-site estimate at (888) 578-4462 and you’ll have a line-item number in hand before a single tile is ordered. Wall tile is the wildcard: full-height marble-look porcelain for a small Westminster bathroom can push the number up by $3,000 – $5,000 on materials alone.
How We Run Vanities, Tile & Fixtures Work Here
This is the sequence we’ve settled into after years of doing it, and it works because every stage gets finished before the next one starts.
Stage 1: Measure, template and settle the layout – one visit, 60 to 90 minutes
We measure the room, check the rough plumbing under the old vanity, and confirm what’s actually behind the drywall. You’ll decide there whether the vanity stays on the same wall or moves, whether the floor tile goes under it or stops at the toe kick, and what fixture finishes you want. We hand you a written scope the same day.
Stage 2: Demo and protect – one to two days
Old vanity, toilet, mirror and floor tile come out. If you’re keeping the tub, we cover it with a hard board, not a moving blanket. During demo we find out what’s hiding: subfloor softness around the toilet flange, a shutoff valve that won’t close, or tile set over drywall. If it’s good news, you hear that too. Any surprise gets a photo and a price before we touch it.
Stage 3: Rough-in and prep – two to four days, and the part people underestimate
We set the new vanity cabinet, re-route or extend supply and drain lines, install the cement backer board with a waterproof membrane, and level the floor. If the subfloor was damaged, it gets swapped out now. Plumbing changes here are what drive most of the schedule and most of the cost delta. New valve and drain assemblies go in before anything is closed up.
Stage 4: Tile and vanity install – three to five days
Floor tile sets first, then wall tile, then grout and seal. We cut around the new vanity legs and plumbing rough-ins with a seam that reads clean. Vanity top lands once the tile is cured. Fixtures – faucet, shower head, tub spout and drain trim – get installed last. Grout cures for 24 hours minimum before any water touches it.
Stage 5: Trim, caulk, punch list and walkthrough – one to two days
Mirror hangs, towel bars and hooks go up, silicone goes down around the sink and shower edges, and we run every fixture. You walk through with us, and you come back with a book of what was installed. Work is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right.
This is part of a full Bathroom Remodeling in Westminster for a lot of homeowners, and when it is, the sub floor and rough-in work above happens in the same schedule.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
- Vanity material and style: MDF with a factory finish handles humidity well and comes in around $600 – $1,200 for a stocked vanity. Solid maple or birch plywood runs $1,200 – $2,500 and lasts longer in a shower-heavy room. Floating vanities free up floor space in small Westminster baths; wall-mounted, they need blocking installed at rough-in.
- Countertop: Quartz is the standard here and Cambria runs $900 – $1,800 for a typical 48- to 60-inch vanity. Porcelain slab looks similar for less; granite holds up but needs re-sealing once a year.
- Floor tile: Porcelain runs $4 – $9 per square foot for material. Travertine and marble look beautiful and cost more, but in a wet room they need sealing twice a year and show water marks. Luxury vinyl plank is cheaper and warmer underfoot but reads as an upgrade over tile that’s worn.
- Wall tile and surround: Full-height porcelain tile gives a custom look and is the most popular option here. Acrylic surrounds cost far less, install in a day, and are easier to clean. Large-format tile (24×48 or larger) reduces grout lines, but needs a very flat wall.
- Fixtures: Grohe, Kohler and similar shower valves and faucets run $150 – $600 per set. Buy the valve and trim together; mixing brands across a single shower gets you a return trip and a mismatch.
- Lighting and vent: A properly sized exhaust fan tied to the switch is not optional in a Westminster bathroom without a window. It’s what stops the new vanity from swelling.
What Vanities, Tile & Fixtures Costs in Westminster, CA
A vanity, tile and fixtures job in Westminster runs $9,000 – $28,000. Where you land depends on these variables:
- Footprint and vanity size: A 5×8-foot hall bath costs less than a master with a double vanity. A double vanity alone adds $1,000 – $3,500 in cabinet, top, plumbing and labor.
- Whether plumbing moves: Same-wall vanity and same tub location keeps you near the low end. Relocating the sink drain or moving a shower valve to a different wall can add $800 – $2,500.
- Tile area and grade: Floor only versus floor plus three walls plus tub surround. Large-format porcelain adds material cost but cuts labor; intricate patterns add both.
- Condition behind the wall: Soft subfloor, non-functioning shutoffs, or tile set over drywall add days and dollars. We price the fix in writing before we proceed.
- Permit scope: Fixtures and finish swaps usually don’t require a permit. Moving drain lines or adding a vent does.
Our written estimate spells out what’s included – demo, materials, install, disposal, caulking – and what’s not: structural repairs, mold remediation, or appliance relocation. Upfront pricing, no surprises. Our technicians have up to 12 years of experience on this exact work.
See the difference
Before
After
Before
After
Before
AfterWhat Westminster Homes Specifically Do to This Job
The bathroom floors we pull up here are almost always 1950s – 1970s original: tile set on a mud bed or plywood, non-code shutoff valves, and cast-iron drain lines that are due. Beach Blvd, Brookhurst St and the tract streets between them run small single-story baths where every inch counts. When the tile comes up we expect to find some soft subfloor near the toilet, and we price that in rather than surprise homeowners with it mid-job. Multigenerational households often want the vanity plumbed for a second sink or an in-law-suite shower added, which means a permit and a rough-in change. And in Little Saigon, plenty of homeowners are pulling permits on a Westminster address for the first time – we walk you through what the city wants and keep the file together for inspection. If the same house is getting exterior work, homeowners often pair this with Tile Roofing in Westminster or Specialty Roofing in Westminster so the whole property is done in one stretch.
Serving Westminster, CA – Our Local Coverage Area
We serve Westminster and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Westminster
Most jobs take 10 to 18 working days from demo to final walkthrough. That breaks down to 1 – 2 days of demo, 2 – 4 days of rough-in and prep, 3 – 5 days of tile and vanity install, and 1 – 2 days of trim and punch list. Jobs that move plumbing or replace subfloor run longer. Call (888) 578-4462 for a schedule estimate on your bathroom.
Usually not if you’re swapping fixtures, tile and a vanity in the same location. You do need one if you’re moving drain lines, adding a vent, or changing the wet-wall layout. We pull permits and pass inspections on the jobs that require them, and we tell you up front which side of the line your job falls on.
Yes – most Westminster jobs don’t move the plumbing. Keeping the vanity on the same wall and the tub and shower in place keeps the job closer to $9,000. If you want a double vanity or a different sink location, that’s fine, but it adds $800 – $2,500 for the drain and supply changes.
All vanities, tile and fixtures work is covered by our 730-Day Done Right Promise. If something isn’t right in those first two years, we come back and make it right. The vanity and fixture brands carry their own manufacturer warranties on top of that.
Plan on $9,000 – $28,000 for vanities, tile and fixtures, with most jobs settling between $9,000 and $16,000 when plumbing stays in place. Material grade, tile area, and condition behind the wall are what move the number. Call (888) 578-4462 for an exact quote – estimates are free.
Get a Free Vanities, Tile & Fixtures Estimate in Westminster
You’ll get a written, line-item estimate on site, a clear schedule, and a straight answer on whether your job needs a permit. We’ll bring finish samples, talk through vanity and tile options in your own bathroom, and leave you with a number that doesn’t move. Groundwork Construction Co. covers Westminster and neighboring areas, and you can see our full Bathroom Remodeling scope if you’re planning more than fixtures and tile. Call (888) 578-4462 – a live person answers 24/7.
Written by the team at Groundwork Construction Co.