Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wood Fence in Yorba Linda, CA: What It Takes and What It Costs
A wood fence in Yorba Linda typically runs $3,500 – $9,000 installed, depending on linear footage, wood grade, height, and gate count. Most residential runs are a 3 – 5 day job from demolition to final trim, and because nearly all of our Yorba Linda work is on built-out lots rather than new construction, the real variables are access, hillside grade, and what the fence is replacing. Call (888) 578-4462 for a free on-site estimate and a written line-item quote before any crew touches the yard.
How We Build a Wood Fence Here, Stage by Stage
There’s no mystery to a good fence, but there is a sequence, and skipping steps is exactly how fences lean after one Santa Ana wind season. Here’s what the 3 – 5 days actually look like.
Stage 1 – Walk the line and set it (day one, half the morning). We stake the fence line, confirm property lines against your plat or a survey if you have one, and identify anything buried along the path: irrigation lines, low-voltage landscape lighting, gas stubs, and the odd root system from old eucalyptus. This is where you decide whether to follow the existing line or straighten it, and whether gates land in the same spots. Moving a gate is a design decision, not a big cost move. Discovering a gas line the hard way is a different story.
Stage 2 – Demo and haul (day one afternoon). Out comes the old fencing, posts, and footings. On Yorba Linda hillside lots this can be the slowest part of the day, because the old posts are sometimes set in clay that’s been baked hard or, worse, in a shallow concrete pour that has to be dug rather than pulled. We haul everything off-site. You don’t need to arrange a dumpster.
Stage 3 – Posts and footings (day two). Posts get set in concrete, on center spacing that matches your panel width, and left to cure. We decide with you at this point whether a retaining curb or grade board is needed where the ground falls away – common on slopes toward the eastern edges of town. This is also when we confirm whether the fence will need a permit (more on that below) and pull it if so.
Stage 4 – Rails, boards, and gates (day three and four). Rails go up first, then the boards, then the gates. Gate hardware gets set with the gate hung and swinging before we call it done – fence companies that skip this step hand you a gate that drags within a year.
Stage 5 – Finish, stain, and walkthrough (day four or five). We cut the tops, install cap or trim, apply a penetrating stain or sealer if you’ve chosen one, clean the site, and walk the whole run with you. Every post gets a tap-check. Every gate gets tested. If something’s off, we fix it before we leave, and everything we build carries our 730-Day Done Right Promise – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between for a Wood Fence
Wood fencing isn’t one product. The choices below are the ones that actually change how the fence looks, holds up, and costs.
- Cedar vs. pine vs. redwood. Cedar is the sensible middle: natural rot resistance, tight grain, holds stain well, and costs more than treated pine but less than clear-grade redwood. Treated pine is the budget choice and can look good for 8 – 10 years if you stain it, but it moves and checks more in dry heat. Redwood in a clear grade is beautiful and expensive – worth it on street-facing runs where the fence is part of the curb appeal.
- Dog-ear vs. flat-top vs. cap-and-trim. Dog-ear boards are the standard and the cheapest. Flat-top with a cap rail reads cleaner and protects the board ends from water. On the custom homes we work on in Yorba Linda, cap-and-trim with a routed top is the one that matches the architecture.
- Board-on-board vs. side-by-side vs. shadowbox. Board-on-board overlaps boards for full privacy with both sides looking finished – worth the extra material on a shared property line. Shadowbox leaves small gaps for airflow and light, which many horse-property owners prefer, but it’s not private.
- Post size and footing depth. 4×4 posts are the baseline. On taller runs or where the fence meets high wind exposure, we spec 4×6 or 6×6 posts set deeper – a modest material increase that adds years of life.
- Height and gates. Six feet is standard. Seven-foot runs need more material and often a permit, and gate size, swing, and hardware (self-closing, latched, or a simple bar) shape the layout more than the fence itself.
- Stain and finish. A penetrating oil-based stain, not a film-forming sealer, is what we recommend for our climate. Film sealers crack and peel in the dry heat; penetrating stains fade gracefully and re-coat every 3 – 5 years.
What a Wood Fence Costs in Yorba Linda, CA
Plan on $3,500 – $9,000 for a typical residential wood fence here. That range covers most 100 – 200 linear-foot runs. The number moves for five reasons:
- Linear footage. The single biggest driver. Every extra 50 feet adds roughly $900 – $1,800 depending on grade and height.
- Wood species and grade. Treated pine sits at the low end; cedar lands mid-pack; clear redwood pushes the top of the range.
- Existing condition and removal. Old posts set in clay or stubborn concrete add demo labor. Occasionally a buried line has to be located and rerouted, which we price upfront.
- Slope and grade. Fences that step down a hill need more posts and panels than a flat run of the same length. On steep lots a grade board or low retaining curb adds material and labor.
- Permits and height. A 6-foot run on a typical lot usually doesn’t need a permit; 7-foot privacy runs and fences near certain setbacks often do. We pull permits when required and handle the inspection.
Every estimate we write is a line-item quote: footage, species, post spec, gate count, stain, permit fees, and haul-away all listed separately. The number you see is the number you pay. What’s not in the base quote unless we’ve discussed it: moving irrigation or electrical lines under the fence line, major soil correction on a slope, and tree trimming if a branch is over the run. We flag every one of those at the walkthrough so there are no surprises mid-job.
See the difference
Before
After
Before
After
Before
AfterWhat Yorba Linda Homes Specifically Do to This Job
Yorba Linda is largely a built-out, high-value foothill suburb. Almost every wood fence we build here is a replacement or a boundary rework on an existing lot, not new construction. That matters because the fence has to work with what’s already there – mature trees, established landscape, and lots that step with the hillside. On the eastern edges toward Chino Hills State Park, the dry Santa Ana wind exposure and expansive clay soils do real damage to fence posts. We routinely see the same failure modes: posts rotted at the soil line after 12 – 15 years, panels blown and leaning after a wind event, and pickets that dried and split because they were never sealed. The 1960s – 1980s ranch and Spanish-style homes throughout ZIP codes 92886 and 92887 often still have their original fencing, so a replacement is a once-in-a-generation project worth speccing right. On the equestrian and estate lots near the horse-keeping zones, board-on-board and heavier post specs are the standard. Homeowners often pair this work with Paver Driveways in Yorba Linda to tie the frontage together, and some pair it with Concrete Driveways & Concrete Work in Yorba Linda when the front is being redone in one pass. If the fence is part of a broader project, see our Fence Installation in Yorba Linda page for the full scope; our Fence Installation service is what the wood work here sits under, and this page is part of our Yorba Linda coverage. When the run gets long or the property line is complex, working the fence and driveway in one pass keeps the equipment and crews from coming through twice.
Serving Yorba Linda, CA – Our Local Coverage Area
We serve Yorba Linda and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked About a Wood Fence in Yorba Linda
Most residential runs take 3 – 5 working days from demo to final trim, with a small 1 – 2 day buffer for inspections if your fence needs a permit. A short 80-foot run on flat ground can finish in 2 days; a long hillside run with multiple gates can stretch to 6. Scheduling around weather is rarely an issue here. Call (888) 578-4462 to get the schedule for your project – the estimate is free.
A standard 6-foot wood fence on a typical lot usually doesn’t require a permit, but 7-foot runs, fences near certain property setbacks, and fences on steep or equestrian-zoned lots often do. We confirm the requirement at the walkthrough before we order material, pull the permit when it’s required, and handle the inspection. Call us for a free estimate and we’ll tell you upfront where your lot falls.
Yes, in most cases we work around existing lines and keep them in place. We locate the lines at the walkthrough with a line-finder before any digging. If a line crosses directly under a post location, the fix is usually a small reroute we price upfront. What we don’t do is dig blind and discover a gas stub or irrigation main the hard way. Call (888) 578-4462 to schedule the walkthrough.
Expect $3,500 – $9,000 installed for a typical 100 – 200 foot run, with footage, species, and slope being the biggest swing factors. A basic treated-pine 6-foot fence sits near the low end; cedar with a cap-and-trim finish on a graded hillside lot lands toward the top. Written line-item quote, no surprises. Call (888) 578-4462 for an exact quote on your run – estimates are free.
Every wood fence we build is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers post failure, panel movement, gate sag, and any installation defect for two full years. It doesn’t cover acts of nature, which is why we spec the post size and footing depth for our wind exposure here. Call (888) 578-4462 to talk through it.
Get a Free Wood Fence Estimate in Yorba Linda
If a wood fence in Yorba Linda is on your list this year, call (888) 578-4462 to schedule a free on-site estimate. We walk the line, mark the gates, measure the run, and email a written line-item quote – typically within a few days. Live person answers the phone around the clock. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off.
Written by the team at Groundwork Construction Co.