Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Bufftech Driveway & Pavers: The Irvine Owner’s Guide
We install Bufftech-compatible driveway and paver systems for Irvine homeowners at $7,000 to $18,000 for a paver driveway, and most straightforward reseating, edge-restraint and surface repairs finish in a single visit. The catch is that on the “pavers” side the part that fails is almost never a part at all; it’s the joint sand, edge restraint or base course, and on anything vinyl, it’s a failed clip, rail or post collar. Most Irvine owners find out the hard way: a paver lifts slightly underfoot after a car parks, a run of panels starts leaning after a hot week, or water pools where it never used to.
Which Bufftech Models This Applies To
Bufftech is a vinyl fence and rail systems line, so when an Irvine homeowner says “Bufftech driveway and pavers” they usually mean one of two things: a vinyl gate or driveway access system that’s failed, or a paver driveway installed alongside it that needs repair. For the vinyl side, the lines are the Classic series (Baron, Berkshire, Chesterfield, Fulton, New Lexington, Sheffield, Sutton, Whitley and similar), with post caps, pickets and rails specific to each. Identify what you have by reading the post cap or the underside of the top rail, then measure the picket width and the rail profile; a 7/8-inch picket from one series won’t seat in another series’ rail correctly, which is the most common wrong-part problem we see in Irvine. Bufftech parts are weather-stable in California heat but color-matched components are série-specific. For paver driveways, there’s no brand part to order; it’s Belgard and similar pavers, plus polymeric sand and edge restraint.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Bufftech Driveway & Pavers Is Failing
- Panels leaning or splaying at the base. Post collars have loosened or the concrete post footing wasn’t set deep enough. In Irvine’s shrink-swell clay, a shallow footing lets the whole run shift.
- Pickets popping out of the rail. A cracked picket notch or a rail that’s warped from heat cycling. Once one notch splits, the picket walks out within a season.
- Paver joints washing out. Polymeric sand has broken down and rainwater is moving through the joints instead of around the driveway. Irvine’s dry spells then wet winters speed that up.
- Pavers settling in a dip. The base course was under-compacted over expansive soil. You’ll feel it before you see it: a low spot where water sits.
- Gate sagging and dragging. The hinge-side post has rotated, or the gate frame has lost its diagonal brace. It shows up as a gate that won’t latch in summer heat.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For an Irvine paver driveway, a full installation runs $7,000 to $18,000 depending on square footage, paver selection and how much base repair is needed. A driveway replacement is $5,000 to $14,000, and resanding or resealing existing pavers is $250 to $700 for a driveway like most Irvine lots. On the vinyl side, panel, post or gate repairs are quoted line by line, with the part, labor and any footing work shown separately so you see where the number comes from. Upfront pricing, no surprises: the number you see is the number you pay, and the 730-Day Done Right Promise backs the workmanship in writing. Driveway work often pairs with other exterior projects; we also handle KraftMaid, Cambria and Silestone for the interior side of the house.
DIY or Call Us?
You can safely check a few things yourself: walk the driveway for soft or rocking pavers, wiggle each Bufftech post to see if the footing is moving, and look at whether gate posts are plumb. What goes wrong DIY is base repair and footing work. Rebuilding a proper compacted base is the difference between a paver driveway that lasts 20 years and one that dips again in two, and reopening a post footing on a vinyl gate risks snapping rails that are already heat-aged. For anything involving the footing, base course or edge restraint, call (888) 578-4462 for a free estimate before you start digging.
FAQs
A properly installed vinyl fence and a correctly based paver driveway both last 20+ years here. Irvine’s heat and dry-wet cycles are the real test: vinyl that’s set with deep footings holds up, while shallow footings over expansive clay are what fail first.
Yes in most cases. A single broken picket, a loose post collar or a settled paver section is usually a targeted repair, not a full replacement. We inspect the cause first, because replacing a part without fixing what made it fail just means doing it twice.
Vinyl picket and post-collar repairs are typically done in a single visit. Paver resanding or localized base repair on an Irvine driveway usually takes a day, and full paver driveway installs run a few days depending on square footage and site access.
We match your Bufftech series to the correct picket, rail or post collar by measuring the profile before ordering, and we source paver and hardscape materials through verified brand partners. Groundwork Construction Co. of Irvine is an independent service provider and is not affiliated with Bufftech; the part selection is matched to your existing system.
Written by the team at Groundwork Construction Co. of Irvine, serving Irvine and nearby areas.