Home additions & ADU
Kitchen remodeling
Bathroom remodeling
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CGI Home Additions & ADU: The Irvine Owner’s Guide
We build and install CGI-compatible additions and ADUs throughout Irvine, and the all-in range for that work runs $45,000 – $130,000 depending on square footage, foundation conditions, and how much of the finish package you take on. Detached ADUs sit higher, starting around $90,000 and running to $220,000. These aren’t parts swaps you book for tomorrow; a real addition is a permitted, multi-week build. Groundwork Construction Co. of Irvine is an independent service provider, not affiliated with CGI.
Owners usually end up on this page the same way. A door that stuck through one Irvine summer now won’t latch. A slab they never looked at has a hairline crack running past a corner. Or the original builder’s “good enough” detailing shows itself during a Santa Ana wind window, and you can see daylight where the addition meets the house. South Orange County’s shrink-swell clay and dry summers are hard on anything that wasn’t detailed for them.
Which CGI Models This Applies To
CGI isn’t a single product line. Depending on what you’re dealing with, “CGI” here means the same handful of building systems we work with on CGI-influenced additions: the wall and structural assembly, the modular panel or panelized frame component, the door and window package the original design called for, and the finish trim package that ties it all together. Compatibility turns on specs, not brand loyalty. The three that matter most in Irvine: window and door rough-opening dimensions, the structural tie-in from the new frame to the existing house, and the roof pitch and overhang so the new roofline actually drains.
To identify what you have, start at the manufacturer label and model line. Every panel and glazing unit carries one, usually on the frame edge or a plate near the mechanical chase. Grab a tape measure and record the rough opening, the wall thickness, and the finished floor-to-ceiling height before you call anyone. Those three numbers rule out most wrong parts on their own.
The OEM-versus-aftermarket call is real for CGI. Original components preserve the exact fit and the original engineering assumptions; quality aftermarket equivalents often cost less and, in some cases, hold up better to Irvine’s climate. What we won’t do is put in a part that only almost fits. A rough opening is within tolerance or it isn’t. “Close enough” on a structural tie-in is how you get crack lines a year later.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your CGI Home Additions & ADU Is Failing
- Doors and windows that stick or won’t latch seasonally. Wood and vinyl frames move with heat and moisture cycles in Irvine, so a bind in August that frees up in January points to framing or settle, not the lock hardware.
- Hairline cracks running past the corners of the addition slab. Shrink-swell clay under Irvine lots moves as the soil dries down, and a crack that migrates diagonally from a corner is usually foundation work that was specified for a different soil profile.
- Daylight or drafts at the seam where the addition meets the house. The flashing and seal at that joint is the most common failure point we see; if air gets through, water eventually does too.
- Stucco or siding cracks above and below openings. These track the structural movement behind the wall finish rather than the finish itself, which is why patching the stucco alone doesn’t hold.
- Roof edge or valley wear where the new roofline ties in. A pitch or overhang mismatch shows up as premature wear on the shingles near the transition, often on the side facing the afternoon sun.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Irvine, home additions run $45,000 – $130,000. Garage conversions sit at $30,000 – $80,000, and standalone ADU construction is $90,000 – $220,000. What drives the number up: square footage, the condition of the slab you’re building on, how far you want to move plumbing and electrical, and how much of the finish package gets upgraded. What keeps it down: a flat site, an existing utility chase close by, and finishes you’ve already selected.
Every quote lays out the scope line by line, so parts and labor don’t blur. Permits are pulled and inspections passed before we close out, and the number in the quote is the number you’ll pay. No change orders you didn’t approve, no mid-job surprises. The work is covered by our 730-Day Done Right Promise, and if something wasn’t done right, we make it right.
DIY or Call Us?
Here’s the honest split. You can safely check and record the symptoms: measure the rough openings, photograph the cracks with a coin or ruler in frame for scale, note the manufacturer label, and take clear pictures of the seam at the house. That’s diagnostic work, and it saves everybody time on the first visit. What you shouldn’t do is try to chase a structural tie-in, correct a slab issue, or re-flash an addition-to-house joint yourself. Those are the things that turn a $2,000 repair into a $20,000 rebuild, and on a permitted structure, unpermitted DIY work can complicate a future sale or inspection.
When the symptoms are more than cosmetic, call (888) 578-4462. Live person on the line, 24/7, no voicemail. Estimates are free, and you’ll get a written line-item breakdown before anyone touches the site.
FAQs
Done right, 30 to 50 years. Done with the wrong tie-in for Irvine’s shrink-swell clay and the sun load, you’ll see problems much sooner, sometimes inside 2 to 3 years. The difference is almost always foundation prep and the seam detailing, not the quality of the panel or finish itself.
Often, yes. A cracked slab corner, a failed seam, or a roofline transition that leaks can usually be corrected without a rebuild. What can’t be repaired is a structural tie-in that was wrong from the start, and that’s a rebuild of the affected section. The honest answer comes after we’ve seen it in person.
Diagnostic repair work usually takes 2 to 5 days on site; a partial rebuild of a tied-in section runs 2 to 4 weeks. Permits and inspections on any structural work add time, and we don’t rush past that. Every quote gives a timeline in writing.
We match the part to your existing label, model line, and measured rough openings before ordering, and we lean on our curated network of builders and material suppliers to find the right fit. You’ll see the part spec and line-item price in your quote. Call (888) 578-4462 for your free estimate. We also work with KraftMaid, Cambria, and Silestone on finish packages that tie into the work.
Call (888) 578-4462 for a free estimate. Calls are answered by a live person 24 hours a day, and we’ll walk through your options, financing, and the $1,000 off projects over $10,000, without pressure. Groundwork Construction Co. of Irvine builds from foundation to finish line, backed in writing.
Written by the team at Groundwork Construction Co. of Irvine, serving Irvine and nearby areas.