Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Delta Driveway & Pavers: The Irvine Owner’s Guide
We install Delta-compatible driveway and paver systems across Irvine, and most full driveway projects here land between $7,000 and $18,000 installed, with smaller repairs and section replacements priced well below that. Irvine owners usually discover a failure the same way: a paver shifts underfoot after a car pulls in, a hairline crack opens along the driveway edge, or water starts pooling against the garage door instead of draining toward the street.
Delta makes hardscape components built to hold up under vehicle traffic, and when a piece of that system gives out, the fix is almost always about matching the exact profile and thickness rather than grabbing whatever paver is stacked at the home center. Get that match wrong and the joint opens again within a season. We’re an independent service provider, not affiliated with Delta, so what follows is what we’ve learned installing and repairing these systems on Irvine properties.
Which Delta Models This Applies To
Delta’s driveway and paver line breaks into a few families, and the one you have determines which replacement component actually fits. The most common in Irvine are the interlocking concrete paver systems, the permeable grid systems used on sloped lots, and the edge-restraint and base-profile components that hold everything together. Each family uses its own thickness and joint spacing, and a 60mm paver will not sit flush against a 80mm base course.
To identify yours, look for a stamp or ink mark on the underside of a loose paver or on the manufacturer tag left at the edge restraint. Measure the length, width, and thickness with a tape in millimeters. Note the color family and surface texture too, since Delta runs multiple finishes under the same model name.
On the OEM-versus-aftermarket question: Delta’s own components are the safest bet for color and dimensional match, especially on visible driveway sections. A quality aftermarket equivalent can work for hidden base and edge components where the color doesn’t show, and it often saves money. We source both and tell you which is which before we order.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Delta Driveway & Pavers Is Failing
Failures on a Delta driveway in Irvine usually trace back to water, base movement, or a single failed component that spreads. Here’s what to watch for:
- Pavers rocking or shifting underfoot. The base course has settled or washed out beneath the paver. In Irvine’s clay-heavy soils, that often happens after winter rain saturates the subgrade.
- Joint sand washing out. Water is moving through the joints instead of across the surface. Left alone, the loss of sand lets pavers loosen and edges chip.
- Edge restraint pulling away. The restraint that locks the driveway border has lifted or cracked, letting the outer course spread. This one cascades fast.
- Pooling against the garage or street. The slope has changed or a low spot formed. Standing water against the slab is the leading cause of the cracks Irvine owners call us about.
- Cracks or spalling on the surface. Freeze-thaw is rare here, but sun, traffic load, and a thin or poorly compacted base will crack and pit pavers over time.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s the honest Irvine pricing, installed, with parts and labor together:
| Work | Typical installed range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Concrete driveway installation | $4,500 – $12,000 |
| Driveway replacement | $5,000 – $14,000 |
| Asphalt driveway paving | $3,500 – $9,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What drives the range: total square footage, whether the base needs rebuilding or just repair, the paver profile and finish, and how much edge restraint and drainage work is involved. Irvine lots on slopes need more base prep and drainage correction, which pushes toward the high end. We give you a line-item quote: the number you see is the number you pay, with no change-order surprises. Every job is covered by our 730-Day Done Right Promise, and the workmanship warranty runs the full term.
DIY or Call Us?
You can safely walk your driveway, check for rocking pavers, and see where water pools. Pulling one loose paver to read its stamp and measure it is fine too, and it helps us quote faster. Where DIY goes wrong here is the base: replacing a top paver without fixing the compacted base or the drainage slope is why DIY driveway patches fail within a season. Getting the base, edge restraint, and grade right is the whole job.
Most of these fixes are done in a single visit once the right part is on hand. Call (888) 578-4462 and a live person answers 24/7, background-checked and uniformed, to schedule your free estimate.
FAQs
How long does a Delta paver driveway last in Irvine?
A properly installed Delta paver driveway typically lasts 25 to 30 years with regular joint sand upkeep and sealing every few years; the pavers outlast the base, which is usually what fails first.
Can failing pavers be repaired instead of replaced?
Yes. If the base under the problem section is sound, we lift the affected pavers, rebuild the base locally, and reset them, which costs far less than a full replacement.
How long does a paver section swap take?
A focused repair or section swap is usually finished in a single visit; a full driveway replacement takes several days depending on square footage and base work.
How do you source the right Delta paver for my driveway?
We match by the stamp, dimensions in millimeters, thickness, color family, and finish, then confirm against Delta’s current line before ordering, using OEM components where color and fit matter and quality aftermarket equivalents for hidden base and edge work.
We also service KraftMaid, Cambria, and Silestone products for Irvine homeowners.
Ready to fix your Delta driveway the right way? Call (888) 578-4462 for a free estimate. Upfront pricing, no surprises, and our 730-Day Done Right Promise behind every job. From foundation to finish line, we’ve got your Irvine property covered – built to last, backed in writing.
Written by the team at Groundwork Construction Co. of Irvine, serving Irvine and nearby areas.