Driveway & pavers
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Driveway & Pavers: The Irvine Owner’s Guide
We install and repair Mr-Glass driveway and paver systems in Irvine. Most paver driveway installations run $7,000 – $18,000 depending on square footage, base prep and paver selection, while sealing runs $250 – $700. When a paver field or base starts slipping, the failure almost always shows up first as a loose corner paver, a wobble you feel walking to the door, or a white salt bloom that won’t rinse off after rain.
Pavers are engineered for load and freeze-safe thermal movement, so the part that actually fails first is rarely the stone. It’s the joint sand, the edge restraint or the base course underneath. Once those give, ruts show up near the driveway apron, joints open up in the sun, and the field starts spreading one summer at a time. In Irvine, where a couple of 100°F-plus stretches land between dry Santa Ana wind days and the occasional heavy rain, that wear cycle runs faster than most homeowners expect.
Key Takeaways
- Mr-Glass paver driveways in Irvine run $7,000 – $18,000 installed; sealing is $250 – $700 as a standalone service.
- The most common point of failure is the base course and joint sand, not the paver itself.
- We repair and install Mr-Glass systems across Irvine: Woodbridge, Turtle Rock, Northpark, Great Park, Quail Hill and older neighborhoods like Westpark.
- Backed by our 730-Day Done Right Promise and upfront pricing, no surprises.
Which Mr-Glass Models This Applies To
Mr-Glass paver systems typically ship in family lines (interlocking field units, edge restraint channels and joint sand) rather than a single “driveway model.” The model identifier lives on the banding strap tag or the paver-specific packing slip, and each unit is stamped or embossed on the side with a nominal size and pattern code. Measure an existing field paver face-to-face before ordering; “4×8” in the paver world often means nominal 4-inch-by-8-inch with a true face closer to 3 5/8 by 7 5/8 inches. That gap matters when you’re trying to match an existing patio apron or walkway.
For repairs, matching the existing paver is the decision point. If the original color or pattern is out of production, we source the closest Mr-Glass equivalent and blend the new field into a low-visibility area (typically a corner or apron edge) so the splice reads clean. When the base is being reworked anyway and the whole field is compromised, full replacement is often the better dollar-per-year answer.
If you’re comparing finishes with other surfaces in the house, we also work with KraftMaid, Cambria and Silestone on the interior side, but those brands don’t cross over into paver specs. The paver system stays Mr-Glass-specific for fit and finish.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Driveway & Pavers Is Failing
These are the symptoms we see most in Irvine, and each one points to a specific cause:
- Loose or rocking pavers near the apron: Joint sand has washed out and the base course has settled. Traffic and irrigation both drink from the same failure point.
- Rutting along the tire line: Sub-base compaction was short of spec at install, or a buried utility trench from the original build settled under the driveway.
- Open joints that won’t stay filled: Edge restraint has lifted or failed. Sand pours out of the field and back into the joint every time it rains.
- White efflorescence that won’t rinse: Moisture is wicking up through the base. That points at drainage, not at surface stains or a cleaning problem.
- Spreading edges or wandering field: The perimeter interlock has broken. Left alone, the field pushes outward one season at a time, and the repair grows with it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Irvine, installed Mr-Glass paver driveway pricing runs:
| Service | Installed Price Range |
|---|---|
| Paver driveway installation | $7,000 – $18,000 |
| Driveway replacement | $5,000 – $14,000 |
| Driveway sealing | $250 – $700 |
| Paver patio installation | $3,500 – $11,000 |
What drives the number: total square footage, base thickness and compaction (rebuilt base adds real cost), paver series selected, perimeter restraint length, and whether drainage is being reworked. We write it line-item and put the number in writing, so you see what the base work, the field, the restraint and the joint finish each cost, with no hidden change orders once we’re on site. Every paver job we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right.
DIY or Call Us?
Honest split. You can safely walk the driveway, mark loose or rocking pavers with chalk, photograph joints and edges, and check that downspouts and irrigation heads aren’t dumping water into the field. That’s useful for the estimate call and nothing more.
Where DIY goes wrong on a paver system is the base course. Re-sanding joints without fixing a settled base just buys months. Replacing a handful of pavers over inadequate compaction loads the neighbors next spring. Pulling edge restraint without knowing what’s holding the interlock can let the field spread. And paver work near the garage threshold or the sidewalk apron has to clear the concrete transition cleanly or you end up with a trip lip on your primary walking surface. That one’s a genuine safety issue for kids and older residents, not just a finish problem.
Call (888) 578-4462 for the walkthrough. Live person, 24/7. Estimate is free.
FAQs
Twenty-five to thirty-plus years when the base is right and joint sand is refreshed every few years. The paver itself will outlast the base. In Irvine’s climate, the two wear points are joint sand loss from summer heat and efflorescence driven by winter rain working down through open joints. Reseal on schedule and the field holds up.
Yes, most of the time. Loose paver sections, failed edge restraint and open joints are all fixable without pulling the whole driveway. Repair stops being the smart money when the base has rutted along the tire line or the field is actively spreading; at that point patching costs more over five years than a full rebuild. We’ll tell you which side of that line you’re on after the walkthrough.
A repair, half a day to a full day. Full paver driveway replacement on an Irvine home in the $7,000 – $18,000 range usually runs 3 – 5 working days for base prep, field installation and joint finish, weather allowing. Rain days push the schedule; we don’t install joint sand onto a wet base.
We identify the unit by embossed stamp, packing-slip code and physical measurement, then source the matching Mr-Glass series through the manufacturer’s channel. If the exact series is out of production, we source the closest current Mr-Glass equivalent and blend the new field into a low-visibility corner so the repair reads clean from the street. Every install is covered by our 730-Day Done Right Promise, and the written quote scopes the part, base work and joint finish before we ever pull up a paver.
Ready to price it? Call Groundwork Construction Co. of Irvine at (888) 578-4462 for a free estimate. Live person, 24/7. We’ll walk the driveway, mark the failing sections and hand you an upfront number, no surprises. Background-checked, uniformed technicians on every job.
Written by the team at Groundwork Construction Co. of Irvine, serving Irvine and nearby areas.