Fence
Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & paversFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Placentia, CA: What It Costs and How Long It Takes
A chain link fence in Placentia typically runs $3,500 to $9,000 installed, with most standard residential lots landing between $4,200 and $6,800. A typical backyard or side-yard run is a one- to two-day job once materials are on site and utility locates are marked. Call (888) 578-4462 for a free on-site estimate and a written line-item quote before anything is ordered.
How we build a chain link fence here, start to finish
Chain link is one of the few fence types where the sequence actually matters to how long the fence lasts. In Placentia’s soil and summer heat, a fence set too shallow or stretched too tight in cold weather will show it within two summers. Here’s the real order of work.
Stage 1: Walk the line and mark utilities (30-60 minutes). We walk the property with you, confirm the exact fence line, and identify gates, corners, and any spots where the fence meets a block wall or the house. Before any digging, you call 811 or we coordinate it, and utility locates get marked. On older Placentia lots this step matters more than people expect – irrigation lines, old gas stubs, and cable runs from previous owners show up in yards that were never mapped.
Stage 2: Demo and layout (2-4 hours). If there’s an old fence, we pull it and haul it off. Then we set string lines and mark post spacing at 8 to 10 feet on center, adjusting for gates and grade changes. You confirm gate swing direction and latch side at this point – changing it later means re-digging.
Stage 3: Dig and set posts (half a day). Terminal posts, corner posts, and gate posts get set in concrete at a deeper depth than line posts because they carry the tension of the whole run. Line posts go in at a shallower depth. Concrete needs to cure before tensioning. On a Friday start we’ll set posts and come back Monday; on a midweek start we can often tension the next day.
Stage 4: Rails, mesh, and tension (3-5 hours). Top rail goes up, mesh gets unrolled and stretched, and tie wires attach the fabric to the line posts. This is where a loose or over-tightened stretch shows. You inspect the run with us before we call it done.
Stage 5: Gates and cleanup (1-2 hours). Gate frames get hung, hinges and latches adjusted, and the site gets swept and hauled out. You get a walkthrough and the 730-Day Done Right Promise in writing – if it’s not done right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Chain link isn’t one product. These are the spec decisions that move both the look and the number:
- Gauge of mesh: 11.5-gauge is the residential standard and holds up fine for most Placentia yards. 9-gauge is heavier and worth it if kids, dogs, or balls hit the fence constantly.
- Coating: Galvanized steel is the budget option but rusts in coastal-influenced air over time. Vinyl-coated (usually green or black) costs roughly 15-25% more and lasts longer, and the dark colors disappear against landscaping instead of shouting “fence.”
- Height: 4-foot for decorative boundary, 5-foot for standard residential, 6-foot for privacy and pool code. Going from 5 to 6 feet adds material and post depth.
- Top rail and tension wire: A top rail gives the fence a cleaner line and rigidity. A bottom tension wire is the cheaper alternative to a bottom rail and keeps dogs from pushing under.
- Gates: Walk gates, double drive gates, and self-closing pool gates are all different assemblies with different hardware. Self-closing, self-latching pool gates have code requirements on hinge and latch placement.
- Post caps and finials: Small cost, mostly cosmetic. Skip the sales pitch – pick what you like.
If your project is part of a full Fence Installation in Placentia plan that includes other fence types along different property lines, we’ll spec the chain link to match height and corner lines so it doesn’t look bolted on.
What Chain Link Fence costs in Placentia, CA
Most Placentia chain link jobs land between $3,500 and $9,000 installed. Here’s how the number breaks down and what pushes it up or down:
| Line item | Typical range |
|---|---|
| Standard 5′ galvanized, 100-150 linear feet | $3,500 – $5,500 |
| 6′ vinyl-coated, 150-200 linear feet | $5,500 – $9,000 |
| Walk gate (installed) | $250 – $550 |
| Double drive gate (installed) | $700 – $1,500 |
| Old fence removal and haul-away | $200 – $600 |
Four things move you to the high end. Linear footage is the biggest driver – a corner lot doubles the run. Grade changes mean stepped panels and more posts, which adds labor. Material grade – vinyl-coated 9-gauge costs meaningfully more than galvanized 11.5-gauge. Access matters too: if a crew can’t get a wheelbarrow to the back line, hand-carrying concrete and posts adds hours.
A written estimate from us lists footage, gauge, coating, post count, gate spec, concrete, demo, and haul-away as separate lines – the number you see is the number you pay. What’s not included unless we state it: permit fees (usually not required for a standard residential replacement, but we’ll tell you when it is), utility relocation, and any repair to damaged hardscape the fence sits on.
See the difference
Before
After
Before
After
Before
AfterWhat Placentia homes specifically do to this job
Placentia is a small, fully built-out North Orange County city covering ZIP codes 92871 and 92870, and almost every fence job here is a replacement on an existing line rather than a new boundary. That changes the work. In the older neighborhoods near the historic downtown and along the old Pacific Electric right-of-way, homes that started as worker housing for the citrus packing houses were expanded lot-by-lot over decades – which means fence lines often don’t follow a clean straight property line. They dogleg around a 1950s garage addition, or sit a foot inside the lot because a previous owner built it that way. We survey the actual line before we dig, not the plat map.
The mid-century stock also matters. Homes built between the 1920s and 1960s, and the 1960s-1980s tract homes that followed, often have shallow pier-and-beam or slab-on-grade foundations with no moisture barrier. When a fence post lands near the foundation, we hand-dig rather than machine-auger so we don’t crack a slab or nick a pier. And the Santa Ana winds each fall mean a chain link fence has to be tensioned right and anchored deep – a fence that looks fine in June will lean after the first big wind event if it wasn’t.
Homeowners in Placentia often pair a new boundary fence with driveway work at the same time to avoid tearing up finished concrete twice – see our Concrete Driveways & Concrete Work in Placentia and Asphalt Driveways & Resurfacing in Placentia services when the fence line meets the driveway apron or a side gate. We cover the whole city through our Placentia service area, and this chain link work fits under our broader Fence Installation service.
Serving Placentia, CA – Our Local Coverage Area
We serve Placentia and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Chain Link Fence in Placentia
A standard residential chain link fence in Placentia takes one to two working days to install once utility locates are marked and materials are on site. Post-setting and curing can add a day if we’re working around a weekend, so plan on a two- to three-day window from start to walkthrough.
Most standard residential chain link replacements in Placentia don’t require a permit, but height, corner-lot sight lines, and pool barriers can trigger one. We check the current requirement against your specific lot before we start and pull the permit if it’s needed – you shouldn’t have to guess.
Chain link fence in Placentia runs $3,500 to $9,000 installed for most residential lots. The low end is a 5-foot galvanized run around 100 feet; the high end is 6-foot vinyl-coated with gates and demo. Call (888) 578-4462 for an exact quote – estimates are free.
No, not on a written line-item quote. We inspect the fence line before we price it, so the footage, gauge, post count, and gate spec are fixed. If we hit something hidden – a buried conduit, a pier, or a property line dispute – we stop and talk to you before doing anything that changes the number.
Every fence we install is covered by our 730-Day Done Right Promise. If a post leans, a gate sags, or the tension goes slack within that window, we come back and make it right.
Get a free chain link fence estimate in Placentia
Call (888) 578-4462 to schedule a free on-site estimate for your chain link fence in Placentia. You’ll walk the line with us, get a written line-item quote with footage, gauge, gates, and demo broken out, and know exactly what’s included before you commit. A live person answers the phone, and our technicians are background-checked and arrive in uniform. Financing is available if you’re bundling the fence with other work.
Written by the team at Groundwork Construction Co.