Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Costa Mesa, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Costa Mesa runs $3,500 to $10,000 and usually takes five to ten working days once demolition starts. The job means pulling the old tub and its surround, reworking the drain and valve, waterproofing the wet area, setting a new shower pan or tile floor, and hanging new wall finish. Most Costa Mesa homes we walk through land between $5,000 and $8,000. Call (888) 578-4462 for a free on-site estimate and a written, line-item number.
How the job actually runs, stage by stage
Conversion work is not the same as a full gut. It touches one wet wall, one drain line, and the waterproofing behind the tile, and each of those has to be done in order. Here’s the sequence we follow so you know what happens on day one versus day five.
Stage 1: Site protection and demolition (day 1)
We lay floor protection and seal off the doorway with plastic so dust stays in the room. Then the tub, surround, and any old drywall or backer come out and get hauled off. You’ll see the framing and the plumbing shutoffs for the first time here, which is where surprises usually surface in older homes.
Stage 2: Rough plumbing and inspection (days 1 – 3)
Because a shower needs a sloped drain and a tub didn’t, the drain gets repositioned and the pan gets built to the right pitch. The valve may get swapped if it’s original to the house. If we’re moving the drain or adding a bench, we open the wall and pull the permit inspection that covers the rough-in. This is the stage that decides whether your job stays near $3,500 or climbs toward the top of the range.
Stage 3: Waterproofing and backer (days 2 – 4)
Once the rough work is signed off, the walls get backer board and a full liquid-applied or bonded sheet waterproofing membrane. This step is the one homeowners can’t see later and can’t skip. A shower that leaks behind the tile in three years almost always skipped or thinned this membrane.
Stage 4: Tile, pan, and finish (days 4 – 7)
Now the visible work goes in: tile walls, the shower floor, niches, and the curb. You’ll want to have chosen your tile and fixtures before this stage, since setting tile is not the point to change your mind. Glass gets templated near the end and installed a few days after, depending on lead time.
Stage 5: Trim, glass, and walkthrough (days 7 – 10)
Final fixture install, caulk, glass, and a water test. We do a walkthrough with you, review how the drain and valve should perform, and hand over the warranty in writing. Your finished shower is typically ready for regular use the day after final caulk cures.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
The spec sheet for a conversion comes down to a handful of decisions. Each one has a real trade-off, and the honest answer isn’t always the premium pick.
- Shower base vs. tiled pan: A prefabricated pan installs in a day and costs less, but the sizes are fixed and the look is plainer. A tiled mortar pan fits odd dimensions and looks custom but adds labor and about $800 to $1,500.
- Tile vs. solid-surface walls: Porcelain tile is the mainstream pick and holds up to daily coastal moisture. Acrylic or solid-surface panels go up fast, cost less, and wipe clean, but they scratch and can look dated in fifteen years.
- Layout: alcove vs. curbless vs. corner: An alcove conversion reuses the tub footprint and is the least expensive path. A curbless entry or a corner unit needs more framing and drain work.
- Glass: framed vs. frameless: Frameless looks sharper and cleans easier at the tracks but adds cost and a couple days of lead time.
- Fixtures: Kohler and similar brands give you reliable cartridges and finishes. A cheap valve is the number-one thing that comes back to haunt a shower.
What Tub-to-Shower Conversion costs in Costa Mesa, CA
Plan on $3,500 to $10,000 for the conversion itself. That’s the shower, not a whole-bath remodel. The variables below are what push a job to the low or high end.
- Footprint and layout: A straight alcove swap is the low end. Curbless, corner, or oversized showers push toward $8,000 – $10,000.
- Condition behind the tub: Rotten framing, a failed old pan, or galvanized drain line means repair work that only shows up after demo.
- Moving plumbing or electrical: Relocating the drain or adding a bench or light is the biggest single cost swing.
- Material grade: Acrylic panels sit near the floor of the range; large-format porcelain with a frameless glass door climbs toward the ceiling.
- Permit scope: A drain relocation or valve change pulls a permit and inspection, which adds cost but protects you at resale.
A written estimate should spell out demolition, disposal, rough plumbing, waterproofing, tile and setting materials, fixtures, glass, permit fees, and cleanup. What often isn’t included, and should be flagged before signing: structural repairs found after demo, any drywall repair outside the shower, and paint.
See the difference
Before
After
Before
After
Before
AfterWhat Costa Mesa homes specifically do to this job
Much of our Costa Mesa conversion work sits on the west side, in the 92627 ZIP codes near the beach, where most of the housing is 1950s and ’60s single-story stucco tract homes on small lots. Those bathrooms were built around a standard tub alcove and were never designed for a tiled shower. We regularly find the original drain and valve still in place, and sometimes early panel wiring running near the shower wall. Salt air and the coastal marine layer west of the 55 also age caulk and grout faster, so we spec a proper waterproofing membrane rather than relying on the tile alone. Near South Coast Metro and the 92626 ZIP, the mix of older tracts and apartments means the same job has a different starting point depending on the home’s era. Costa Mesa also scrutinizes permits closely, so any drain or valve change gets inspected. If you’re tackling the wider room, this often pairs naturally with our Bathroom Remodeling in Costa Mesa work, and homeowners sometimes pair the project with exterior jobs like Tile Roofing in Costa Mesa while crews are already on site.
Serving Costa Mesa, CA – Our Local Coverage Area
We serve Costa Mesa and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Tub-to-Shower Conversion in Costa Mesa
Most conversions take five to ten working days from demo to final walkthrough. A simple alcove swap with prefabricated parts can finish closer to five days, while a custom tiled shower with a bench or curbless entry runs nearer ten, plus a few days of glass lead time. Call (888) 578-4462 for a schedule based on your exact bathroom.
You need a permit when the drain or valve is relocated or replaced. A cosmetic finish swap that reuses the existing drain in the same spot sometimes doesn’t require one, but we check the current city requirements on every job before we start. Call (888) 578-4462 and we’ll tell you what your specific job needs.
Yes. Reusing the tub’s footprint keeps the drain roughly in place and stays near the $3,500 to $6,000 end of the range. The trade-off is you keep the alcove size and curb. Moving the drain or going curbless is what pushes the job higher and pulls in a permit.
Expect $3,500 to $10,000, with most homes landing between $5,000 and $8,000. The range depends on layout, condition behind the tub, material grade, and whether plumbing moves. Call (888) 578-4462 for a free written estimate – the number you see is the number you pay.
Every conversion is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That’s backed in writing and covers workmanship well beyond the standard year. Call (888) 578-4462 to review the details before you commit.
Get a free estimate for your conversion
If you’re ready to trade the old tub for a shower that fits how you actually live, start with a free on-site estimate. We measure the space, walk through the options, and hand you a written line-item price with no surprises. Call (888) 578-4462 today. A live person answers around the clock, and we’ll confirm a visit that works for you.
Often the conversion is one piece of a larger scope. Our Bathroom Remodeling service covers the full room, and we handle projects across Costa Mesa and the surrounding area. When the exterior needs attention too, homeowners often pair this with Metal Roofing in Costa Mesa.
Written by the team at Groundwork Construction Co.