Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Stanton, CA: What the Job Actually Involves
Cabinets & countertops in Stanton, CA runs $14,000 – $45,000 for a typical kitchen, and most projects take two to four weeks from demolition to final caulk. You’re replacing the boxes and the tops, re-setting the plumbing and electrical that feed them, and dialing in door and drawer alignment on walls that were framed when Eisenhower was president. Call (888) 578-4462 and we’ll walk your kitchen, measure the walls for square, and put a real number in writing.
How We Run a Cabinet and Countertop Job, Start to Finish
Every Stanton kitchen we touch follows the same five stages. The order matters, because doing it out of sequence is how you end up with a countertop that doesn’t fit the cabinet run.
- Stage 1, template and order (day 1, about 90 minutes on site). We measure every wall, check for out-of-square corners, and confirm where the sink, range, and outlets land. You decide door style, finish, and layout at this meeting. Cabinets and counters go on order the same week; lead times from our KraftMaid and Cambria lines typically run two to four weeks in Orange County.
- Stage 2, tear-out and prep (days 1 – 2 of construction, two days). Old cabinets, counters, and backsplash come out. We cap the plumbing, isolate the electrical, and repair any drywall or subfloor we uncover. On Stanton’s postwar homes this is where we usually find a surprise: a wall that isn’t plumb, or a floor that’s out of level by an inch across the run. You decide then whether we shim and float or open the wall and fix it properly.
- Stage 3, cabinet set (days 2 – 4, two to three days). Base and wall cabinets get leveled, shimmed, and screwed to studs. We scribe filler panels to the walls so the gaps read as design, not error. You confirm hardware placement before we drill a single hole.
- Stage 4, countertop template and install (days 5 – 15, depending on material). Stone counters get templated after the cabinets are set, then fabricated and installed. Laminate or butcher block can go in the same visit. Sink and faucet set the same day the top lands. You pick the edge profile and confirm the sink cutout before fabrication starts.
- Stage 5, final walk (day of completion, about an hour). Doors and drawers get adjusted, toe kicks go on, and we walk the job with you. Anything that doesn’t line up gets corrected before we call it done, which is what the 730-Day Done Right Promise is for.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Most of the decisions that move your price and your satisfaction happen in two categories: the boxes and the tops. Here’s the honest trade-off on each.
- Stock cabinets: The cheapest path, usually $4,000 – $7,000 for a standard Stanton kitchen. Fixed sizes, limited finishes. Fine for a rental or a quick flip, thinner on long-term durability.
- Semi-custom (KraftMaid): The sweet spot for most homeowners. $8,000 – $13,000 installed, with real plywood boxes, dovetail drawers, and enough finish options to match the house. Lead time runs longer, but it’s the line we specify most often.
- Custom cabinetry: Built to your exact wall dimensions. $15,000+ and a longer schedule. Worth it on tight infill lots where every inch counts.
- Quartz (Cambria): $3,500 – $6,500 installed. Non-porous, no sealing, holds up to Stanton’s dry inland heat without issue. The default choice for busy households.
- Granite: $2,500 – $5,000. Natural stone, needs periodic sealing, but a good slab is a one-of-a-kind. Slab selection matters more than brand here.
- Laminate or butcher block: $2,000 – $3,000. Laminate has come a long way; butcher block is warm and cheap but wants oiling twice a year. Both suit a rental or a budget-conscious flip.
Want to see the full scope beyond cabinets and counters? That lives on our Kitchen Remodeling in Stanton page.
What Cabinets & Countertops Costs in Stanton, CA
Plan on $14,000 – $45,000 for a full cabinet and countertop replacement in Stanton. The spread depends on five things:
- Kitchen size and cabinet count: A 10×10 galley lands near the low end; a kitchen with an island and full wall runs pushes toward $35,000+.
- Cabinet grade: Stock, semi-custom, or custom, a $7,000 swing on its own.
- Countertop material: Laminate versus quartz is roughly a $3,000 – $4,000 difference on a standard run.
- Plumbing and electrical relocation: Moving the sink or range adds $1,500 – $4,000 for permits, rough-in, and patch-back.
- Condition of the walls and floor underneath: Out-of-square walls and unlevel floors cost real money to correct, and Stanton’s 1950s stock has plenty of both.
Your written estimate lists cabinets, counters, labor, haul-away, and permit fees line by line. It doesn’t list structural repair, appliance delivery, or backsplash tile unless we call those out separately, so ask before you sign. Pricing is upfront: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Stanton Homes Specifically Do to This Job
Stanton is a 3.1-square-mile city that’s been nearly built out since the 1950s, and that changes a cabinet job in ways it wouldn’t in a newer suburb. Almost every house we work in is a small postwar stucco tract home on a narrow lot, and the kitchens were designed for a fraction of the appliances and storage we expect today. The walls are rarely square and the floors are rarely level. We plan for that in the template stage rather than discovering it mid-install.
Permitting here runs through a city with heavy multifamily and small-business redevelopment pressure along Beach Blvd and Katella Ave, so review timelines shift week to week depending on what else is in the queue. If your project includes any structural change, a wall removal, or a relocated gas line, expect an inspection cycle. If it’s a straight cabinet-and-counter swap with plumbing in the same spots, it usually doesn’t need a permit, which is the fastest path to a two-to-three-week turnaround. Our climate helps: hot dry summers and mild winters mean construction runs year-round without weather delays. Santa Ana wind events bring dust through open doorways, so we tent the work area and clean daily.
Homeowners across Stanton often pair a new kitchen with a bathroom upgrade while the crews are already on site. Walk-in showers are a common add-on, which is where our Walk-In Showers & Shower Remodeling in Stanton work comes in. Others prefer a tub-to-shower conversion instead. Both are worth pricing in the same visit if you’re planning more than one room.
Serving Stanton, CA – Our Local Coverage Area
We serve Stanton and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Cabinets & Countertops in Stanton
Two to four weeks from demolition to final walk for a typical job, with cabinet and counter lead times adding another two to four weeks of waiting before construction starts. Stone counters add a template-and-fabrication gap of about a week after cabinets are set. Call (888) 578-4462 for a schedule specific to your kitchen.
Usually no, if you’re keeping the plumbing and gas in the same locations and not touching structure. Moving a sink, relocating a gas range, removing a wall, or changing a window requires a permit and inspection. We pull permits and pass inspections as part of the job, and we tell you upfront which category your project falls into.
Yes, and most Stanton jobs we do keep the sink and range in place, which saves $1,500 – $4,000 and shortens the schedule. The catch is that you’re working around the existing layout, including whatever the original 1950s builder decided. We’ll tell you honestly whether keeping the plumbing is worth it or whether a small relocation unlocks a much better kitchen.
$14,000 – $45,000 for a typical full replacement, with cabinet-only work running $4,000 – $13,000 and counters alone at $2,000 – $6,500. The price moves with kitchen size, cabinet grade, countertop material, and whether plumbing or electrical relocates. Call (888) 578-4462 for an exact quote – estimates are free.
Every project we complete is covered by the 730-Day Done Right Promise: if it isn’t done right, we make it right, for two full years after final walk. Manufacturer warranties on KraftMaid cabinets and Cambria counters run separately and we hand you the paperwork. Call for the full terms before you commit.
Get a Free Cabinets & Countertops Estimate in Stanton
Call (888) 578-4462 to schedule a free on-site estimate for cabinets & countertops in Stanton. We’ll measure the kitchen, flag anything that will move the price, and hand you a written line-item quote with no surprises. A live person answers around the clock, so you’re never stuck in voicemail. Our Kitchen Remodeling team handles the wider scope when you’re ready for it, and our technicians bring up to 12 years of experience to every job.
Written by the team at Groundwork Construction Co.