Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Window Replacement in Irvine, CA: what it costs and how long it takes
Window Replacement in Irvine, CA runs $4,500 to $15,000 for most homes, and a typical whole-house job takes two to four working days on site. Vinyl units land at the low end; wood-clad and coastal-rated aluminum push toward the top. The number hinges on unit count, frame material, and how much stucco repair each opening needs. Call (888) 578-4462 for a free on-site estimate with a written, line-item quote.
How we run a window replacement, stage by stage
Every job follows the same sequence. Here’s what actually happens, and what you’ll be deciding at each point.
Stage 1: On-site measure and written scope (day 0, about 90 minutes). We measure every opening, check the existing frames for rot, and photograph the interior and exterior trim. You get a written quote the same visit with per-unit pricing, not a lump sum. This is where you decide which openings get replaced now and which can wait.
Stage 2: Order and permit (week 1 to week 4). Units are ordered to spec and, where the scope requires it, we pull permits through the City of Irvine building division. Irvine’s plan check is strict, and we build the review time into the schedule rather than discovering it mid-Job. You’ll confirm frame color and glass package here. Lead times depend on the manufacturer and the finish you choose.
Stage 3: Demo and prep (day 1, most jobs). We protect floors and furniture, pull the old units, and inspect what the frame was hiding: rotted framing, water staining, missing flashing. Exterior stucco around each opening gets cut back clean. Any surprise we find is priced and approved in writing before we continue.
Stage 4: Install and seal (days 1 through 3). New units are set, shimmed, and leveled. We flash the openings, seal with exterior-grade caulk, and re-stucco and patch the interior drywall returns. Two installers typically set six to ten units a day, depending on size and access.
Stage 5: Inspect and hand-off (final day). If the scope triggered a permit, the city inspection happens before we close out. We test every unit for smooth operation and lock function, walk you through each opening, and leave the written workmanship warranty. All of it is backed by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll actually choose between
Most of the cost difference comes down to frame material and glass package. Here’s the honest trade-off on each.
- Vinyl frames: the lowest-cost path, typically the bulk of a $4,500 to $9,000 job. Good thermal performance, low maintenance, and a limited color range. Best for budget-focused replacements on interior-facing openings.
- Wood-clad and fiberglass: the middle to upper tier. Real wood interior with an aluminum or fiberglass exterior that holds color. Holds up against Irvine’s UV and dry heat better than bare wood. Costs more, suits a full-house job where finish matters.
- Coastal-rated aluminum: the top of the range for a standard replacement. Doesn’t warp, doesn’t rot, and resists the salt-air corrosion that inland-grade hardware struggles with. The right pick for homes near the coast and for openings that take direct sun.
- Glass package: dual-pane low-E is standard on most Irvine jobs. Tempered glass is required in specific locations near doors and low sills. Adding it per opening moves the total modestly.
- Frame color and grid style: a finish upgrade, not a structural one. It changes the look, not the performance.
What Window Replacement costs in Irvine, CA
Most Irvine homes fall between $4,500 and $15,000 for Window Replacement. Here’s how the number is built.
| Line item | Typical range |
|---|---|
| Standard vinyl window replacement (whole house) | $4,500 – $9,000 |
| Wood-clad or fiberglass (whole house) | $9,000 – $13,500 |
| Coastal-rated aluminum (whole house) | $10,000 – $15,000 |
| Stucco repair and flashing per opening | Priced per job, in the written quote |
| Permit fees (where required) | Passed through at cost, itemized |
Five things push the price toward the high end: unit count (a 10-window job and a 24-window job are different projects), frame material grade, how much stucco and drywall repair each opening needs, second-story access, and permit scope.
Your written estimate covers units, labor, flashing, sealing, stucco patch, interior drywall returns, debris haul-away, and the workmanship warranty. What it does not cover unless itemized: custom shapes, full stucco re-finish beyond the openings, and structural reframing if the existing frames are found to be compromised during demo. Upfront pricing, no surprises: the number you see is the number you pay for the stated scope.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine homes specifically do to this job
Irvine is a master-planned city, and that changes how windows get replaced here. Most work happens inside village-specific HOAs and design-review boards, not across a patchwork of independent jurisdictions. A window replacement that goes in without village association approval can be flagged after the fact, so we check the CC&Rs and architectural standards before a single unit is ordered. Neighboring Santa Ana or Tustin homes rarely face that layer of scrutiny. The city’s own building division is also strict on plan check, and where a permit applies, the inspection happens before final hand-off.
The housing stock shapes the work too. Irvine’s homes are overwhelmingly post-1965 planned-community construction: Mediterranean and Spanish-revival stucco tract homes and townhomes in Woodbridge, Northwood, and Turtle Rock, plus dense 2000s-era condo clusters near the Spectrum and UCI. On 30- to 50-year-old tract homes, we routinely find the original aluminum frames have lost their seals and the stucco around them has cracked from UV and dry heat. The semi-arid climate with hot summers and Santa Ana wind events means windows and their seals take a beating, and the almost-total absence of freeze means the failure is sun-driven, not cold-driven. Along the eastern and southern edges abutting open space and the Santa Ana foothills, Irvine enforces wildland-urban interface fire-hardening rules, and ember-resistant venting and noncombustible detailing around the openings routinely trip up out-of-area contractors on their first Irvine plan check. We build for that from the first measure.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked – Window Replacement in Irvine
Most jobs take two to four working days on site, plus the order lead time. Whole-house jobs run longer than a handful of openings, and second-story access adds time. Call (888) 578-4462 for a timeline estimate on your specific home.
Often yes, depending on scope and whether the opening size changes. Irvine’s building division reviews plans carefully, and village HOA design approval may also apply. We pull the permits and handle the inspection as part of the job. Call with your address and we’ll tell you what your scope triggers.
In most cases, yes. Standard replacement fits the new unit into the existing opening, so no plumbing or structural work is involved. Full-frame replacement, where the entire frame comes out, is a bigger job that can expose framing issues, and we price that clearly before work starts.
Most Irvine homes fall between $4,500 and $15,000, with vinyl at the low end and coastal-rated aluminum at the top. Unit count, frame material, and stucco repair drive the number. Call (888) 578-4462 for an exact quote – estimates are free.
Every job is covered by our 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If something isn’t done right, we make it right. Manufacturer coverage on the units runs separately and is explained in your written estimate.
Get a free estimate for Window Replacement in Irvine
We provide free on-site estimates for Window Replacement in Irvine. A live person answers the phone around the clock, and you’ll get a written, line-item quote during the visit. If your project is part of a wider plan, see our Windows & Doors service or the full Windows & Doors in Irvine page. Homeowners often pair this with a Vinyl Fence in Irvine or an Aluminum Fence in Irvine to finish the exterior. Call (888) 578-4462.
Written by the team at Groundwork Construction Co.