Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Santa Ana, CA: What It Costs and How Long It Takes
A tub-to-shower conversion in Santa Ana typically runs $3,500 – $10,000 and takes 4 to 8 working days from demo to final inspection. The job means removing the existing tub and its surround, reworking the drain and valve to shower height, waterproofing the wet wall, then setting a new shower pan and tile or panel walls. Most Santa Ana homes we see fall between $6,200 and $8,900 once plumbing and valve work are included. Call (888) 578-4462 for a free on-site estimate with a written line-item quote.
How a Tub-to-Shower Conversion Actually Runs, Stage by Stage
There’s a real sequence to this work, and knowing it takes the mystery out of the schedule and the check you write. Here’s what happens in a Santa Ana home, in order.
Day 1: Protection, demo, and the reveal
We mask floors, seal off the rest of the bathroom, and pull the tub, surround, and any glass doors. This is the messy day. It’s also the day we find out what’s behind the wall. In Santa Ana’s older wood-frame homes, that’s often a surprise: a valve tucked too tight, drywall furring that has to be rebuilt, or a drain line that doesn’t line up where it should. We open the inspection hatch and photograph everything before we make changes.
Day 2: Rough plumbing and valve relocation
The drain gets the shower-style linear or center placement, and the mixer valve moves up to shower height. In a bathtub-to-shower conversion, this is the step that most often moves the price. If the existing drain is already centered under the tub, we only rework the top few inches. If it’s offset, the drain line has to be cut and re-sloped, which adds a half-day and $300 – $900 depending on how much framing is in the way. You see that number before we cut.
Days 3 – 5: Waterproofing, substrate, and tile
We install cement backer board or a foam waterproof system, tape and mud the seams, and apply a liquid or sheet membrane. Then comes tile or panel walls. A standard 3-by-5 shower footprint with 8-inch subway tile and a porcelain pan runs about two and a half days of setting and grouting. A mosaic pattern, built-in niche, or bench adds 1 to 2 days. You pick the tile and finish before this stage, and you approve a layout mockup with grout lines marked.
Days 6 – 7: Glass, fixtures, and the visible finish
The glass enclosure goes in, the valve, showerhead, and body spray get installed, and we seal penetrations. This is where a conversion starts to feel finished. It’s also where the Grohe or Kohler fixtures you picked go from a box in the garage to something you’ll use every morning. We run the water, check temperature and flow, and verify the shower pan drains fully without a puddle.
Day 8: Inspection and punch list
If the project required a permit (and most conversions do), the Santa Ana inspector signs off on plumbing and waterproofing. We do a final walkthrough, point out the drain cleanout, remind you of the tile cure time, and leave a punch list with any small touch-ups. Most jobs are 6 to 8 business days. Tight historical or HOA-reviewed bathroom spaces can stretch to 10.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between in a Shower Conversion
A conversion is really a series of material decisions, and each one has a trade-off you should know before you pick.
- Tile walls vs. panel walls: Tile is the premium choice, $18 – $42 per square foot installed depending on grade, and it lasts decades with proper grout care. Panel systems run $12 – $25 per square foot and install in a day, which shortens the schedule by 2 days. Panels suit homeowners who want a clean, low-maintenance surface and don’t want to re-grout.
- Shower pan and liner vs. foam base: A layered shower pan with a waterproof liner is the reliable standard for tile jobs and costs $500 – $1,200 installed. A prefabricated foam base is $350 – $900 and accepts tile, with a faster install and wider size selection. Both work; foam is the faster route.
- Frameless glass vs. framed enclosure: A frameless low-iron panel looks larger and cleaner, $1,200 – $2,900 installed. A framed unit is $700 – $1,400 and holds up better in tight clearances where a door needs to swing into a narrow spot. Most Santa Ana bathrooms are small enough that clearance drives this choice.
- Valve and showerhead upgrades: A standard pressure-balance valve is fine and often comes with the fixture package. A thermostatic valve, $450 – $900 extra, gives you precise temperature control and suits homes with older plumbing that runs hot and cold.
- Bench, niche, and grab bars: A tiled bench is $400 – $800, a niche is $150 – $450, and grab bars are $80 – $200 each. These are small line items, but plan them before waterproofing. Retrofitting after the membrane goes on means tearing it back out.
Grohe and Kohler both offer a full range of shower valves and trim, and those are the names we reach for most often. CertainTeed and Owens Corning aren’t part of a shower job, but they show up when homeowners pair this bathroom work with a roof or attic exhaust upgrade.
What Tub-to-Shower Conversion Costs in Santa Ana, CA
Plan on $3,500 – $10,000 for a tub-to-shower conversion in Santa Ana. The low end is a same-footprint swap with a prefabricated pan, a standard valve replacement, and panel walls. The high end is a custom tile shower with frameless glass, a built-in bench and niche, relocated drain, and upgraded fixtures.
What pushes a job toward the high end:
- Bathroom size and footprint: A generous walk-in area with more tile square footage costs more to set and grout.
- Existing plumbing condition: Galvanized lines and old valve rough-ins often need replacement once the wall is open, $400 – $1,500.
- Structural work and framing: Moving a shower end wall, sistering joists under a heavier pan, or fixing dry-rot adds $500 – $2,000.
- Material grade: Porcelain vs. natural stone, and framed vs. frameless glass, can swing the job by $2,000 or more.
- Permit scope: A plumbing permit and inspection add to the total but protect the resale value of the home.
A written estimate from us lists demolition, protection, plumbing, waterproofing, tile setting, glass, fixtures, permit, and cleanup as separate lines. It doesn’t include major structural repair discovered mid-job, which we price in writing before we proceed, and it doesn’t include a full bathroom remodel, which is a separate scope. The number you see is the number you pay for the listed work. If you’re widening the project while the walls are open, that’s better planned as part of our Bathroom Remodeling in Santa Ana service, and we can scope both in one visit. Our Bathroom Remodeling team handles the larger layout changes, and our shower conversion crew handles the focused swap.
See the difference
Before
After
Before
After
Before
AfterWhat Santa Ana Homes Specifically Do to This Job
Santa Ana’s housing stock dates mostly from the 1920s through the 1960s, and that changes what a shower conversion feels like here. In Wilshire Square and French Park, we routinely find knob-and-tube wiring feeding the bathroom light and old galvanized supply lines under the tub. The result: a conversion that one week becomes three days longer because the valve rough-in needs new supply lines and the electrician has to bring the circuit up to current code before the inspector will sign off. The city’s historic preservation rules in Lacy and French Park mean some exterior or structural changes need design review, though an interior tub-to-shower swap typically stays inside the plan-check lane. Mid-century tract homes in ZIP codes 92701, 92707, and 92735 have the opposite problem: easy access, but shallow stud cavities that force us to fur out the shower wall an inch so the valve fits. Santa Ana’s semi-arid climate means we don’t lose days to rain, which helps the schedule. It also means the shower pan has to be sealed tightly against a foundation that swells in the wet season. Our Santa Ana service area covers all of these neighborhoods.
Serving Santa Ana, CA – Our Local Coverage Area
We serve Santa Ana and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Tub-to-Shower Conversion in Santa Ana
Most conversions take 4 to 8 working days, with 6 being typical for a 3-by-5 shower with tile walls and a frameless enclosure. Custom tile layouts, a relocated drain, or major plumbing repairs push it to 10 days. Call (888) 578-4462 for a schedule built around your start date.
Yes. Moving the drain or valve for a shower conversion counts as plumbing work, and the city requires a permit and inspection. We pull the permit and meet the inspector on your behalf, and the inspection pass is part of the job. Call us for a quote that includes the permit fee.
Often, yes. If the tub drain and valve sit where a shower pan can use them, we keep the rough-in and only raise the valve to shower height. That keeps the job in the $3,500 – $6,500 range. The only way to know for sure is a quick on-site look, so call (888) 578-4462 to book a free estimate.
Most Santa Ana conversions land between $3,500 and $10,000. A prefab pan with panel walls and a framed enclosure sits near the low end; a custom tile shower with frameless glass, a bench, and upgraded Grohe or Kohler fixtures sits near the top. Call (888) 578-4462 for an exact written quote at no cost.
Every conversion we install is covered by the 730-Day Done Right Promise, so if the waterproofing, tile, or plumbing fails within that window, we return and make it right. That guarantee is in writing and applies whether you stay in the home or sell. Call (888) 578-4462 to ask about coverage details for your Santa Ana project.
Book Your Free Tub-to-Shower Conversion Estimate in Santa Ana
We’ll walk your bathroom, measure the footprint, check what’s behind the tub wall, and hand you a written line-item estimate within a day. There’s no charge for the visit, and the price you see is what you pay. Financing is available at 0% for 18 months, and projects over $10,000 take $1,000 off. Meanwhile, the shower conversion and our roofing crews often work on the same home together, so if you’re planning a Metal Roofing in Santa Ana or Tile Roofing in Santa Ana project, we can coordinate the two visits. Call (888) 578-4462 to schedule yours.
Written by the team at Groundwork Construction Co. of Irvine.