Kitchen remodeling
Bathroom remodeling
Home additions & ADU
Roofing
Windows & doors
Driveway & pavers
FenceFree written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Backsplash, Tile & Flooring in Irvine: What It Costs and How Long It Takes
Backsplash, tile & flooring work in Irvine typically runs $14,000 – $45,000 for a full kitchen tile and flooring package, with a backsplash alone at $800 – $2,500 and tile flooring priced by the square foot. A single backsplash goes in over two to three days; a full floor-and-wall package with demo and prep runs two to three weeks. Call (888) 578-4462 for a free on-site estimate with a written, line-item quote.
How We Sequence Backsplash, Tile & Flooring Work
Tile is unforgiving. A floor that’s off by a quarter inch at the doorway telegraphs itself across the whole room, and a backsplash set against a wall that isn’t plumb will show a widening grout line you can’t unsee. So the schedule below is built around prep, not around tile-setting speed.
- Day 1: demo and site protection. We pull the old backsplash, cut out failed flooring, and mask cabinets and counters. If the existing tile sits on drywall, the drywall usually comes out with it, which is normal and gets priced in up front.
- Days 1 – 2: substrate and layout. This is the stage that decides how the finished job looks. We check the subfloor for deflection and level, install cement backer board where it’s needed, and dry-lay the tile so you approve the layout, grout joint width, and where cuts land. You’ll decide tile direction, grout color, and trim profile here, before anything is permanent.
- Days 2 – 4: backsplash set and grout. A standard backsplash behind counters and range goes up in a day, gets grouted the next, and is ready for the range hood and outlet covers on the third. Mosaic sheets and hand-made tile take longer because every sheet gets straightened.
- Days 4 – 10: floor tile. Large-format floor tile over a prepared substrate runs about 150 – 250 square feet a day for a two-person crew. Grout follows 24 hours after the last tile is set, and foot traffic resumes the day after grout.
- Final walkthrough and close-out. We seal natural stone, reinstall outlet covers and appliances, and walk the job with you under the 730-Day Done Right Promise. Any lippage, hollow tile, or grout issue gets corrected before we call it finished.
You decide three things and only three things: the tile itself, the layout, and the grout. Everything else is on us. If the tile scope is part of a wider rebuild, it slots into our Kitchen Remodeling service, which handles the cabinetry and countertops around it.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Tile and Backsplash Options You’ll Actually Choose Between
Most Irvine homeowners land on one of four backsplash directions and one of three flooring directions. Here’s the honest trade-off on each, not the showroom version.
- Ceramic and porcelain subway tile. The workhorse. $8 – $20 per square foot installed, forgiving of minor wall imperfections, and easy to keep clean. It’s the best value in the category and holds up for decades.
- Large-format porcelain slab. Fewer grout lines and a modern look, but the material is heavier, needs a flatter wall, and costs noticeably more to set. Suits a full-height backsplash behind a range hood where you want one continuous face.
- Natural stone (marble, travertine, quartzite). Beautiful, and porous. It needs sealing on a schedule, and in a kitchen it will etch from citrus and vinegar. Choose it because you want the look, and plan on maintenance.
- Porcelain plank and large-format floor tile. The default for Irvine kitchens and laundry rooms. Durable, water-resistant, and it handles the hot-dry climate without the expansion issues wood can show. Grout joint width and color are the biggest aesthetic decisions.
- Luxury vinyl plank for floors. Lower material cost and warmer underfoot, but it’s a different product category with a shorter lifespan than tile. We’ll tell you plainly when it makes sense and when it doesn’t.
Fixture and trim details matter more than people expect. A Grohe faucet or a properly sized sink cutout in the backsplash changes the whole read of the wall, so we finalize those before tile is ordered.
What Backsplash, Tile & Flooring Costs in Irvine, CA
Residential tile work in Irvine ranges from $800 for a small backsplash to $45,000 for a full kitchen floor-and-wall package. The line items below are what our written estimates look like.
| Scope | Typical Irvine Range |
|---|---|
| Backsplash installation | $800 – $2,500 |
| Full kitchen floor tile | $2,000 – $6,500 |
| Full backsplash, tile & flooring package | $14,000 – $45,000 |
Five variables push a job from the low end to the high end:
- Square footage and tile size. Larger tile means fewer cuts per square foot but heavier pieces and more careful substrate work.
- Existing condition. Cracked substrate, water damage under the sink, or a floor that needs leveling adds days and material.
- Layout complexity. A herringbone floor or a diagonal pattern can add 15 – 25% to labor versus a straight set.
- Material grade. Porcelain slab and natural stone sit well above ceramic on both material and setting cost.
- Anything that touches plumbing or electrical. Relocating a sink or adding an outlet in the backsplash means opening the wall, and that’s the line item most likely to surprise you if it wasn’t on the quote.
Your written estimate should spell out demo, substrate, setting materials, grout, trim, and cleanup line by line. It should not bury a “miscellaneous” line. Upfront pricing means the number you see is the number you pay, which is why we put it in writing before a single tile is ordered.
See the difference
Before
After
Before
After
Before
AfterWhat Irvine Homes Specifically Do to This Job
Irvine is a master-planned city, and that changes tile work in ways out-of-town contractors miss. Most of our jobs sit inside village HOAs with design-review boards, so a flooring change in a condo near the Spectrum or a backsplash swap in a Woodbridge townhome may need association approval before material is ordered. We build that approval window into the schedule, because the alternative is a crew sitting idle while a tile delivery waits on a signature.
The housing stock drives the failure modes too. Irvine’s 1960s – 1980s tract homes in Northwood and Turtle Rock often have original tile set over mud beds or thin-set that’s given up after four decades. Pull up a floor in a 1970s Northwood ranch and you’ll frequently find cracking at the cabinet edges where the subfloor has flexed. Post-2000 condos near UCI usually need the opposite work: the tile is fine, but the grout has shrunk and the caulk joints at the baseboard have opened up from dry heat. Irvine’s hot, semi-arid summers and Santa Ana wind events stress those joints every year, so we spec flexible caulk at all changes of plane instead of grout.
If your tile project is the first step in a larger rebuild, it’s often part of a full Kitchen Remodeling in Irvine. We cover the city broadly, so this work also fits naturally alongside our Irvine service pages.
Serving Irvine, CA – Our Local Coverage Area
We serve Irvine and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked About Backsplash, Tile & Flooring in Irvine
A backsplash takes two to three days; a full floor-and-backslash package with demo and prep runs two to three weeks. Timeline depends on HOA approval windows and whether the substrate needs work.
A cosmetic backsplash change usually does not require a permit; structural changes, plumbing relocation, or new electrical inside a wall often do. We tell you which category your job falls into before work starts and pull what’s needed through the city’s building division.
Yes, in most cases. We set the new backsplash over the existing wall or add backer board without touching cabinetry. If you want a sink moved or a new outlet, that becomes a separate line item and we price it up front.
Most full packages in Irvine run $14,000 – $45,000 depending on square footage, tile grade, and existing condition. A backsplash alone is $800 – $2,500. Call (888) 578-4462 for an exact quote; estimates are free.
Every tile and backsplash job is covered by our 730-Day Done Right Promise. If a tile lifts, a grout joint fails, or the work isn’t what you approved, we come back and fix it. Homeowners often pair tile work with a Tub-to-Shower Conversion in Irvine or Vanities, Tile & Fixtures in Irvine, and both fall under the same promise.
Get a Free Estimate for Backsplash, Tile & Flooring in Irvine
Tell us the room, the square footage, and what’s there now. We’ll come out, measure, and hand you a written line-item estimate for your Irvine backsplash, tile & flooring project, with no change orders hiding in the fine print. Call (888) 578-4462 and a live person picks up, any hour. Ask about $1,000 off projects over $10,000 and 0% financing for 18 months.
Written by the team at Groundwork Construction Co.